Ridgid RP 115 Mini Press Tool Battery Kit with ProPress & PureFlow Jaws 1/2-3/4

Description

Cramped sink vanities and narrow crawlspaces demand ultra-compact joining equipment for residential water line work. The Ridgid RP 115 Mini Press Kit supplies 15 kN of crimping power for 1/2in and 3/4in copper and PEX lines. While featherweight and compact, this mini tool cannot crimp 1in or larger commercial pipe sizes.

A lightweight composite motor housing couples to a precision-machined aluminum hydraulic pump barrel. The 12V micro motor pulls 9A under full hydraulic load, delivering reliable piston stroke force. Weighing just 2.9 lbs bare, the tool spans 13.0in long by 4.5in wide. Its micro inline profile allows single-handed operation between tight residential wall studs, while forged alloy steel mini jaws endure repeated pressing stress without jaw pin elongation.

Key Features of Ridgid RP 115

Residential service plumbers buy Ridgid RP 115 kits to complete domestic repairs in tight vanity cabinets without dangerous torch flames. Transparent retail pricing makes this mini press platform cost-effective for high-volume emergency service trucks.

• Micro inline architecture weighs 2.9 lbs to enable single-hand overhead pipe pressing.
• Swiveling 210-degree head articulates past residential drain pipes inside narrow vanity cabinets.
• Delivers 15 kN hydraulic thrust to press 1/2in and 3/4in copper and PEX.
• Includes ProPress jaws for copper tube plus PureFlow jaws for PEX fittings.
• Single-trigger control executes the full crimp stroke with automatic ram return action.
• Slim grip handle features textured rubber to stop hand slippage in wet repairs.
• Efficient 12V lithium battery platform yields over 140 crimps per single charge cycle.

Hydraulic Mini Bench Pressure Metrics

Dynamometer bench testing verifies a steady 15 kN clamping force across ProPress and PureFlow joint profiles. Cycle duration completes in 3.5 seconds on 3/4in copper couplings. Jaw pin hinge runout holds below 0.0003in TIR across repeated test cycles. Motor housing temperature rises 22°F above ambient room temperature after 30 consecutive presses. The internal relief valve trips at 3,200 PSI to direct hydraulic fluid back to the reservoir without over-compressing copper fittings.

Jobsite Usability Routine Maintenance Rules

Slim handle geometry suits single-hand operation with light mechanics gloves, firing via a sensitive 3 lbs trigger pull. The integrated nose light highlights dark pipe niches behind drywall cutouts. Do not purchase this mini tool for commercial schedule 40 steel pipe jobs or copper tubing exceeding 3/4in diameter.

• Apply ISO 32 machine oil to jaw latch pins every 30 operating hours.
• Wipe grit from the micro hydraulic piston shaft using clean dry cloths every 50 press cycles.
• Check jaw closing alignment and spring tension with gauge blocks before each work shift.

Warranty Protection Kit Packout Manifest

Ridgid covers the tool body under their Full Lifetime warranty against defects in materials or assembly. The kit includes the mini press tool, two 1/2in and 3/4in ProPress jaws, two 1/2in and 3/4in PureFlow jaws, two 12V 2.5Ah batteries, a charger, and a blow-molded case.