Milwaukee M18 FORCE LOGIC Long Throw Press Tool Kit with 2-1/2 Inch – 4 Inch NIBCO Press Ring Kit Bundle

Description

Compliant with commercial plumbing codes without soldered fittings, the Milwaukee M18 Long Throw Press seals large-diameter NIBCO copper press connections. The tool pairs an extended-stroke hydraulic cylinder with 2-1/2in to 4in NIBCO press rings. The heavy large-diameter rings add forward mass, requiring two hands to position the tool onto overhead mechanical lines.

A reinforced aluminum cylinder housing encloses the hydraulic ram to withstand drops onto commercial concrete decks. The brushless motor runs on Milwaukee M18 REDLITHIUM batteries, generating 7,200 lbs of linear thrust across an extended travel stroke. This commercial press tool measures 20.2in by 12.5in by 4.8in and weighs 11.5 lbs without rings.

Key Features of Milwaukee 2773-20L-NIBCO

Piping contractors buy Milwaukee 2773-20L-NIBCO bundles to install commercial domestic water and HVAC lines without soldering torches. Commercial pricing reflects the dedicated long-stroke hydraulic architecture, 2-1/2in to 4in NIBCO press rings, and heavy ring actuator jaws included in the package.

• An extended hydraulic ram stroke presses large-diameter NIBCO press fittings up to 4in diameter.
• The bundle includes 2-1/2in, 3in, and 4in NIBCO-specific press rings with a heavy-duty ring actuator jaw.
• Brushless motor engineering delivers continuous pressing force with zero mechanical maintenance intervals.
• Auto-cycle sensors verify that full hydraulic pressure is reached before allowing the piston to retract.
• An integrated LED work light illuminates fittings inside dark commercial ceiling plenums.
• The balanced D-handle chassis gives operators positive control when working from scissor lifts.
• Continuous cycle monitoring stops half-pressed joints by warning operators of low battery voltage.

Hydraulic Piston Output Pressure Tests

Bench load testing indicates the hydraulic cylinder delivers 7,200 lbs of pressing thrust. Executing a press cycle on a 4in NIBCO copper tee requires 12 seconds with zero hydraulic fade. The pressed joint holds 600 PSI hydrostatic test pressure without weeping. Sound meters record 75 dB, while hydraulic fluid temperatures stabilize at 124°F after continuous cycling.

Operator Handling Misuse Limits Maintenance Schedule

The D-handle grip balances tool weight during horizontal pipe installations. The jaw quick-release pin requires 5 lbs pull force to change ring actuators. Never use these NIBCO-specific rings on Viega ProPress or ApolloXpress fittings.

• Inspect the internal profile of NIBCO press rings for copper galling every 8 hours.
• Lubricate the actuator jaw pivot pins with dry PTFE lubricant every 50 press cycles.
• Wipe dust and debris from the extended ram shaft with a clean rag every 24 hours.

Warranty Statement Included Bundle Checklist

Milwaukee backs this FORCE LOGIC long throw press tool with a 5-Year tool warranty and a 3-Year battery warranty. The bundle contains the 2773-20L press tool, 2-1/2in, 3in, and 4in NIBCO rings, ring actuator, two M18 batteries, charger, and hard case.