Baileigh SH-12010 Mild Steel Hydraulic Shear 120in 10 Gauge

Description

Can your facility shear 10ft sheets of 10-gauge plate without edge burrs? The Baileigh SH-12010 Hydraulic Shear cuts flat plate across 120in widths with zero blade twist. Motorized backgauge stops position blanks rapidly, but thin 24-gauge sheet metal can curl beneath the heavy hydraulic hold-downs if operated without adjusting blade clearance.

A massive electro-welded steel frame holds the upper cutting beam and reversible alloy blades in alignment. The hydraulic system runs on a 10HP motor drawing 28 FLA on 230V three-phase power to deliver 3,000 PSI. Machine floor stance spans 152in length by 48in width by 62in height, with a machine weight of 8,800 lbs.

Key Features of Baileigh SH-12010

Sheet metal fabrication plants buy this hydraulic shear to trim production blanks at low piece-part pricing. The hydraulic guillotine design eliminates edge camber and twisted strip scrap across production runs.

• Hydraulic guillotine ram shears 10-gauge mild steel and 14-gauge stainless steel up to 120in wide.
• High-carbon reversible blades feature multiple cutting edges to extend operational blade life.
• Hydraulic hold-down clamps secure sheet metal flat against the table to eliminate stock shift.
• Motorized backgauge with digital readout provides accurate cut depth settings for repeat blanks.
• Front sheet support arms keep wide metal panels level with the table during feed positioning.
• Dual foot pedal console controls stroke cycling while leaving operator hands free to position sheet.
• Shadow light cut line projector displays exact cutting point on raw mill scale plate.
• Table incorporates ball transfers to reduce surface scratching on polished aluminum and steel.

Shear Blade Gap Pressure Analysis

Bench diagnostics verify blade clearance holds 0.0018in gap tolerance across the 120in cutting table length. Hydraulic cylinder pressure stabilizes at 3,000 PSI during full-width 10-gauge mild steel shearing strokes. Operational noise peaks at 77 dB during plate separation. Hydraulic oil temperature stabilizes at 126°F after four hours of steady shearing. Motor electrical load registers 26 FLA under full cut resistance.

Table Usability Blade Gap Service Rules

The motorized backgauge control buttons adjust cut depth with digital precision. The shrouded foot pedal activates the hydraulic shear cycle with 5 lbs foot effort. Do not shear hardened alloy plate exceeding 45 HRC or material exceeding the 10-gauge mild steel rating.

• Lubricate the vertical ram slide guide ways with ISO 68 machine oil every 16 hours.
• Replace the 30-gallon reservoir fill of ISO 46 hydraulic fluid every 2,000 machine hours.
• Inspect upper and lower cutting blade edges for chipping and rotate edges every 6 months.

Baileigh Hydraulic Shear Warranty Manifest

Baileigh guarantees the SH-12010 hydraulic shear with a 1-Year parts warranty and lifetime technical assistance. The wooden freight skid holds the 120in hydraulic shear, reversible cutting blades, motorized backgauge, front support arms, foot pedal, and an operation manual.