Edco Magna-Trap Heavy-Duty Dual-Disc Floor Grinder

Description

Level uneven warehouse slabs and remove thick floor coatings using the heavy Edco Magna-Trap Dual-Disc Grinder across cured concrete. Magnetic tooling discs let operators swap diamond segments in seconds without hand tools. It profiles concrete fast but requires dedicated 230-volt single-phase power circuits. Counter-rotating discs cancel operational torque to prevent operator fatigue.

ASTM gray cast iron forms the heavy disc housings, gear compartments, and lower chassis frame. A heavy 5-horsepower electric motor draws 20 full-load amps at 230 volts through a commercial plug. Double V-belts transfer power from motor pulleys to dual drive shafts. The bare unboxed grinder weighs 290 lbs, measuring 44 inches long, 27 inches wide, and 37 inches high.

Key Features of Edco 58100

Floor preparation specialists buy Edco 58100 grinders to level curled slab joints without wasting time on wedge tooling. Commercial dual-disc floor machine pricing delivers decades of reliable surface flattening on heavy industrial contracts.

• Magna-Trap magnetic accessory discs allow rapid tooling swaps without wooden wedges or hammers.
• Five-horsepower electric motor provides reliable continuous torque without tripping thermal relays.
• Counter-rotating dual discs cancel out operational torque to give operators smooth directional control.
• Heavy cast iron chassis delivers 160 lbs of grinding head pressure without add-on weights.
• Dual three-inch vacuum ports capture fine concrete dust when paired with industrial extractors.
• Heavy-duty double V-belt drive isolates the electric motor from harsh slab impact shocks.
• Multi-position handlebar adjusts to operator working height to reduce fatigue on long grinding shifts.
• Solid rubber transport wheels roll through wet slurry without marring prepped concrete surfaces.

Magnetic Tool Retention Down-Pressure Tests

Testing shows the Magna-Trap magnetic disc pockets hold diamond segments secure under 140 foot-pounds of shear torque. The 5 HP motor maintains 250 disc RPM under continuous drag on 4000-PSI concrete. Downward head pressure measures 160 lbs across both discs, stripping 600 square feet of sealer per hour. Vacuum ports capture 95 percent of airborne dust under 200 CFM suction.

Dedicated 230V Circuit Warnings

Loading this 290-lb cast iron grinder into work vans demands two strong workers and sturdy ramps. Do not buy this 230-volt machine if your jobsite only provides 115-volt residential electrical outlets. Long undersized extension cords cause voltage drops that overheat motor capacitors. Check magnetic pockets for metal shavings before seating tooling.

• Inspect drive belt tension every forty operating hours and adjust motor slide rails.
• Grease disc shaft bearings every fifty hours using water-resistant wheel bearing grease.
• Clean magnetic tool pockets with brass wire brushes before seating new diamond segments.

Factory Warranty Hardware Manifest

Edco covers this Magna-Trap floor grinder with a 1-Year warranty against material defects and drivetrain mechanical failures. The factory shipment includes one dual-disc grinder, two Magna-Trap multi-accessory discs, a dust port adapter, and an instruction manual.