Edco CPM-10E 7.5 HP 230/460V 3-Phase 10in Walk-Behind Crete Planer

Description

Mill faulted sidewalk trip hazards and strip road paint using the heavy-duty Edco CPM-10E Electric Crete-Planer on commercial concrete slabs. A 7.5-horsepower three-phase motor spins a ten-inch cutter drum across high aggregate. It chews concrete fast but requires dedicated three-phase power drops. A manual hand crank sets drum cutting depth into pavement.

Heavy 7-gauge structural plate steel and welded box tubing form the rigid chassis and cutter drum cage. A 7.5-horsepower electric motor runs on 230/460-volt three-phase power driving the cutting shaft through double V-belts. Sealed flange bearings protect drum drive shafts from abrasive concrete dust. The unboxed scarifier weighs 360 lbs, measuring 45 inches long, 24 inches wide, and 40 inches tall.

Key Features of Edco 69200

Industrial flooring contractors buy Edco 69200 planers to remove thick epoxy mortar toppings and scarify factory floors. Commercial electric scarifier pricing delivers zero-emission surface milling inside enclosed food processing and manufacturing facilities.

• Seven point five horsepower three-phase motor delivers relentless cutting torque without engine exhaust fumes.
• Dual-voltage 230/460-volt electrical setup adapts to varying commercial plant power supplies.
• Ten-inch cutting drum width profiles large concrete expanses and strips floor coatings in single passes.
• Fine-pitch hand crank adjustment sets drum depth in thousandths of an inch to stop over-cutting.
• Tungsten carbide flail cutters shatter hard concrete aggregate without fracturing the slab base.
• Three-inch vacuum shroud port attaches to high-CFM dust collectors for clean silica containment.
• Heavy steel construction delivers steady downward weight over cutters to stop drum bounce.
• Quick-release hand lever raises the cutter drum off concrete instantly for fast turnaround moves.

Three-Phase Cutter Drum Load Tests

Tachometer testing shows the 7.5 HP electric motor holds 1750 RPM under full drum cut on 4500-PSI cured concrete. Running current stabilizes at 18.2 amps on 230-volt three-phase power without motor thermal overload trips. Dynamic vibration measures 4.0 Gs at the drum housing during full-depth scarification passes. The 7-gauge steel chassis maintains square alignment without weld fatigue.

Three-Phase Wiring Site Cautions

Operating this 360-lb electric scarifier requires two hands on the handle grips to maintain straight tracking lines. Do not buy this three-phase machine if your facility only provides single-phase electrical power. Running on incorrect phase wiring can spin the cutter drum backward and damage tungsten cutters. Always run industrial dust collectors during indoor work.

• Inspect tungsten carbide cutter tips for chipped edges or flat spots every twenty operating hours.
• Grease drum shaft flanged bearings every forty hours using extreme pressure chassis grease.
• Blow fine stone dust out of the electric motor housing vents after every four hours of work.

Factory Warranty Hardware Manifest

Edco covers this electric scarifier with a 1-Year warranty against frame weld cracking and manufacturing defects. The factory crate includes one CPM-10E Crete-Planer, a loaded tungsten carbide cutter drum, a vacuum port adapter, and manuals.