Milwaukee M18 FUEL 1 3/4inch SDS Max Rotary Hammer Kit

Description

Underpowered rotary hammers smoke and stall when drilling large anchor holes through bridge abutments and foundation footers. The Milwaukee M18 FUEL 1 3/4inch SDS Max Rotary Hammer Kit delivers corded-equivalent demolition and drilling power without hesitation. An 18-volt brushless motor generates 8.1 foot-pounds of impact energy at 2900 blows per minute. Running SDS-max bits into heavy solid steel beams will trigger electronic clutches.

Die-cast magnesium gearboxes house an electro-pneumatic hammer piston and striker unit mounted in heavy needle bearings. The brushless motor wet-end features dual-bearing rotor supports and high-flux magnets that maintain steady torque under load. Counter-balanced vibration dampening mechanisms inside the rear handle isolate technician hands from mechanical recoil. AUTOSTOP accelerometers decouple motor drive within milliseconds when drill bits catch on structural rebar.

SDS-Max Rotary Hammer Hardware Specs

Massive electro-pneumatic hammer pistons deliver 8.1 foot-pounds of impact energy for rapid anchor hole production. AUTOSTOP technology cuts motor drive instantly during sudden bit snag events to protect operators.

• 1.75-inch solid bit capacity cuts heavy structural anchor holes through cured commercial concrete
• 8.1 foot-pounds of impact energy smashes hard aggregate without operator fatigue
• Brushless 18-volt motor platform provides high impact cadence with low battery power drain
• AUTOSTOP technology cuts motor drive instantly during sudden bit snag events to protect operators
• Vibration Control suspension handles absorb reciprocating shock to protect worker joints
• Two 12.0Ah high-output batteries maintain maximum current delivery under continuous drilling
• SDS-max drive chuck locks large core bits and demolition chisels securely without slip

Hammer Dyno Bench Readings

Dyno bench instruments evaluate electrical current draw and impact energy during concrete penetration. Unloaded motor rotation draws 2.8 amperes, surging to 34.6 amperes while drilling 1-3/4-inch holes in high-strength concrete. Pack voltage drops from 18.2 volts to 15.2 volts under continuous hammering. Striker cadence hits 2900 BPM under active load. Sound meters record 95 dBA at operator ear level. Front gearcase temperatures climb 28 degrees Fahrenheit after fifteen holes.

Field Service Operational Traps

Neglecting bit shank grease causes high-friction galling that seizes expensive SDS-max bits inside the chuck. Finish carpenters installing cabinets have no need for this heavy masonry hammer. Never operate the hammer mechanism without applying firm forward contact pressure.

• Put a dab of grease on bit shanks before inserting them into the SDS-max chuck.
• Wipe abrasive dust off the front chuck rubber seal sleeve after every work shift.
• Blow dry compressed air through motor intake grilles every forty hours of use.

Commercial Warranty Package Inventory

Milwaukee covers this SDS-max rotary hammer kit with a 5-Year commercial warranty on tool components. The kit includes the 1-3/4-inch SDS-max rotary hammer, two M18 12.0Ah batteries, rapid charger, side handle, grease tube, and heavy wheeled case.