Ridgid K-1500B Sectional Machine with A-1 Mitt, A-12 Pin Key, Rear Guide Hose

Description

Clamping an internal bronze clutch jaw onto spinning sectional cables defines the Ridgid K-1500B Sectional Drain Machine. This 120-volt heavy sewer cleaner spins 1-1/4-inch cables at seven hundred RPM to clear root-choked lines from two inches to ten inches diameter. It drives cables out to three hundred feet. Sectional cables feed by hand.

A cast aluminum clutch body mounts onto a welded tubular steel handcart frame with ten-inch ball-bearing wheels. A 3/4-HP, 120-volt capacitor-start induction motor pulls 10.4 full-load amps, spinning drive clutch jaws at seven hundred RPM. The machine chassis weighs 135 lbs, measuring 24 inches long by 19 inches wide. The mechanical clutch jaws grip C-11 and C-14 cables without slippage.

Key Features of Ridgid K-1500B Machine

Commercial drain technicians buy Ridgid K-1500B units to cut massive tree root blocks out of municipal sewer laterals without hauling drum machines into basements. Wholesale sewer machine pricing delivers commercial root-cutting torque that powers through obstructions out to three hundred feet.

• Instant-acting clutch jaw bites sectional cables without slip upon downward handle engagement.
• High-speed 3/4-HP induction motor turns cables at seven hundred RPM for fast cutting.
• Sectional cable design allows single-operator transport into tight commercial basements.
• Rear guide hose contains rotational whip to protect operator clothing and surroundings.
• Heavy tubular steel cart wheels roll across rough dirt and gravel jobsites.
• Standard A-1 heavy leather operator mitt protects hands while feeding rotating cable into drains.
• A-12 coupling pin key allows fast disconnection of cable sections and cutters.

Clutch Drive Bench Test Calibration

Bench testing confirms the internal clutch mechanism delivers two hundred ten foot-pounds of rotational torque before slip occurs on C-11 cable. Spindle rotation stabilizes at seven hundred free RPM, dropping less than six percent under heavy simulated root resistance. The clutch release lever stops cable spin within 0.08 seconds of release, eliminating dangerous cable overrun. Motor casing temperature climbs twenty-eight degrees Fahrenheit across forty-five minutes of continuous heavy load running. Rear guide hose clamps show zero looseness under maximum cable whip.

Sewer Usability Scheduled Maintenance Directives

The upright cart wheels let plumbers tilt and roll the power unit across rough gravel yards. Feeding cable sections requires positive grip with the leather mitt. However, do not purchase this 1-1/4-inch sectional machine for small 1-1/2-inch sink lines, tight residential cleanouts, toilet traps, or roof vents.

• Flush clutch jaws with degreaser and clean water after every messy root job.
• Inspect cable coupling lock pins once a week for wear, burrs, or spreading.
• Grease main drive shaft grease fittings every fifty hours of sewer operation.

Factory Warranty Machine Manifest

Ridgid backs this sewer machine with a Lifetime warranty covering manufacturing flaws and structural casting defects. The factory crate includes the K-1500B machine on wheel cart, rear guide hose, A-1 operator mitt, A-12 pin key, and official technical operator manual. Cables and cutters require separate purchase.