Oztec Industries 1.25 HP Electric Concrete Vibrator Motor

Description

Meets OSHA indoor air quality thresholds on tight commercial concrete pours where exhaust gases face heavy municipal fines. The Oztec 1.25 HP Electric Vibrator Motor provides single-phase electric torque to drive pencil vibrator heads. It spins pencil heads up to twelve thousand vibrations per minute. This motor cannot run large two-inch vibrator heads without tripping overload circuits.

A high-impact cast aluminum motor housing dissipates internal winding heat while resisting wet cement paste corrosion. A universal single-phase brush-type electric motor draws nine full-load amps on standard one hundred fifteen-volt circuits, spinning at twelve thousand free-load RPM. Total unboxed motor weight sits at eleven-point-five pounds. External dimensions measure fourteen inches long by six inches wide. Double-insulated electrical wiring eliminates the need for separate chassis ground prongs on jobsites.

Key Features of Oztec 1.2-OZ

Concrete framing crews buy Oztec 1.2-OZ motors to consolidate stair risers, thin precast panels, and light residential basement walls. Commercial vibratory equipment pricing reflects the durable aluminum casting that protects motor windings from jobsite drops.

• One-point-twenty-five horsepower electric motor provides continuous rotational speed inside sticky concrete mud.
• Universal electrical system plugs into standard one hundred fifteen volt twenty amp household outlets.
• Quick-disconnect shaft coupling locks flexible drives tight without hand tools.
• Rugged cast aluminum frame withstands six-foot jobsite scaffold drops onto cured slabs.
• Eleven-and-a-half-pound total tool weight reduces back strain during continuous overhead wall consolidation.
• Thermal overload reset button trips before winding varnish overheats during motor stall binds.
• Heavy-duty toggle power switch resists concrete slurry intrusion and functions with muddy gloves.

Motor Load Stall Current Benchmarks

Bench dynamometer load testing records an operational drop from twelve thousand free RPM down to ten thousand five hundred loaded RPM in three-inch slump concrete. Continuous current draw pulls eight-point-eight amperes under five-foot flexible shaft load. Thermal overload cutoff triggers after four minutes of sustained mechanical rotor stall, protecting motor copper windings from burnout. Internal armature shaft runout measures below one-point-five mils, minimizing drivetrain vibration transfer back through the flex shaft casing to the operator hand.

Jobsite Ergonomics Maintenance Negative Target

The tubular handle frame balances the motor against your hip, keeping the power cord behind your feet during wall pours. The large recessed toggle switch flips on with thick work gloves. Do not buy this compact motor to drive massive heads over one-and-one-half inches or shafts longer than fourteen feet.

• Inspect carbon motor brushes every one hundred run hours and replace at half-inch length.
• Blow wet cement dust from motor ventilation slots using dry compressed air every seven days.
• Clean inner drive coupling teeth with solvent before locking flex shafts in place.

Factory Warranty Manifest Crate Contents

Oztec Industries backs this electric power unit with a standard 1-Year limited industrial manufacturer warranty. The factory package contains the 1.2-OZ electric vibrator motor, tubular steel roll-protection bracket, an extra set of motor carbon brushes, and an illustrated parts breakdown manual.