Multiquip 1.1 Inch Head 120V 280W Electric Hand-Held Concrete Vibrators

Description

Precast fabricators crack slender architectural forms when utilizing oversized consolidation pokers in crowded rebar spaces. The Multiquip UM12810 Hand-Held Concrete Vibrator delivers high-frequency vibration through a slender one-point-one-inch head to settle delicate castings. It provides a three-point-three-foot flexible reach. This compact motor bogs down if forced into stiff low-slump foundation mixes.

Durable double-insulated thermoplastic encases the high-speed electric motor to resist moisture and concrete splatter. The compact motor draws two-point-eight amps at one hundred twenty volts single-phase, producing two hundred eighty watts of power at thirteen thousand vibrations per minute. Unboxed tool weight measures eleven pounds. Dimensions span forty-six inches from the rear motor grip to the head tip. High-tensile steel forms the one-point-one-inch diameter poker head.

Key Features of Multiquip UM12810

Precast panel builders buy Multiquip UM12810 units to settle architectural concrete mixes around tight internal window frames. Handheld concrete vibrator pricing reflects the lightweight motor housing that eliminates operator arm fatigue during overhead pours.

• One-point-one-inch slender steel head consolidates tight spaces between dense wire mesh.
• Two hundred eighty watt motor spins the eccentric weight at thirteen thousand VPM.
• Three-point-three-foot flexible drive shaft maneuvers around complex precast form hardware.
• Double-insulated electrical construction protects the operator without separate ground wires.
• Ergonomic rear spade handle provides positive directional control inside narrow form openings.
• Built-in trigger lock holds continuous motor speed during repetitive consolidation cycles.
• Light eleven-pound overall mass prevents shoulder strain over eight-hour precast shop shifts.

Slender Head Dynamometer Bench Metrics

Bench dynamometer testing demonstrates that the eccentric weight reaches thirteen thousand vibrations per minute in open air, settling at eleven thousand eight hundred VPM in five-inch slump mix. Motor current draw rises from two-point-three amps free to two-point-eight amps under full head immersion. Internal winding temperature levels off at one hundred thirty-five degrees Fahrenheit after thirty minutes of continuous operation. Spindle runout holds within one mil, preventing flex shaft whip and preserving smooth vibration transfer into precast forms.

Shop Handling Maintenance Negative Fit

At eleven pounds, this handheld vibrator balances with one hand, allowing the free hand to adjust form ties or trowel mud. The spade handle trigger operates with thin rubber shop gloves. Do not buy this small-head tool for deep structural commercial footings or stiff two-inch slump mass pours.

• Wipe cement slurry from the motor ventilation slots after each pour.
• Inspect flexible casing ferrule crimps every thirty days for structural looseness.
• Check motor carbon brushes every fifty run hours for brush face wear.

Manufacturer Warranty Package Crate Contents

Multiquip covers this handheld tool under a 1-Year limited industrial warranty against defects in material and workmanship. The factory package contains the complete UM12810 vibrator with integrated three-point-three-foot shaft, attached one-point-one-inch steel head, grounding plug adapter, and an official operational service manual.