MBW BullVibe with Battery and Charger

Description

High-frequency eccentric rotors spin inside an enclosed aluminum body to drive surface paste to the slab top in a single floating pass. The MBW BullVibe Concrete Float Vibrator mounts directly onto bull float extension handles to consolidate concrete surfaces. It includes a battery and charger. This surface unit cannot consolidate deep structural slabs like internal poker vibrators.

Machined aircraft-grade aluminum forms the sealed vibrating body to resist corrosion from wet concrete slurry and washdown water. An enclosed direct current electric motor runs off an eighteen-volt lithium battery pack, generating adjustable vibration frequencies up to five thousand cycles per minute. Total tool weight equals six-point-five pounds with battery installed. Housing dimensions measure nine inches long by four inches wide. Stainless steel hardware clamps onto standard bull float brackets.

Key Features of MBW BullVibe

Concrete flatwork finishers buy MBW BullVibe units to seal slab surfaces and bring up rich cement paste in one walking pass. Bull float vibrator pricing reflects the lightweight aluminum casing and included battery system that eliminates hand trowel fatigue on large pours.

• Adjustable vibration speed dial matches float action to concrete slump conditions.
• Universal clamp fits standard two-hole and four-hole bull float handle brackets.
• Aircraft-grade aluminum housing withstands jobsite drops and concrete slurry exposure.
• Rechargeable eighteen-volt lithium battery delivers up to four hours of continuous float run time.
• Six-and-a-half-pound lightweight body maintains float balance without sinking blade edges.
• High-frequency surface agitation closes aggregate voids and embeds rock below the surface.
• Sealed water-resistant construction allows wet sponge washdown at the end of the pour.

Surface Vibration Frequency Bench Testing

Bench testing demonstrates that the eccentric rotor delivers an adjustable frequency range from two thousand to five thousand vibrations per minute under load. Battery power draw pulls one-point-five amperes at peak speed, delivering over four hours of continuous float run time on a single battery charge. Housing temperature stabilizes at one hundred twelve degrees Fahrenheit under constant operation. Clamp bracket bolt torque withstands fifty foot-pounds without thread deformation, ensuring rigid attachment to bull float extension handles during aggressive push-pull passes.

Finishing Usability Maintenance Negative Realities

Weighing six-point-five pounds, the tool mounts above the float bracket without disrupting blade pitch or float balance. The speed dial rotates with slurry-covered finishing gloves. Do not buy this surface vibrator attachment to consolidate deep concrete slabs or replace deep immersion poker vibrators inside wall forms.

• Sponge wash concrete paste off the aluminum body before paste hardens.
• Inspect clamp mounting bolts for tightness before walking the bull float.
• Keep battery terminal contacts clean of dried cement paste and grit.

Commercial Warranty Terms Factory Manifest

MBW covers this concrete finishing tool with a standard 1-Year commercial manufacturer warranty against defects in materials and workmanship. The factory package contains the complete BullVibe vibrator unit, one eighteen-volt lithium battery, one battery charger, stainless steel handle mounting hardware, and an official technical operation manual.