NaceCare Solutions WVD 1802DH K-8026610 20 Gallon Dual Motor Wet Pump-Out Vacuum with Continuous Pumping and C3A Toolkit – 1600W

Description

High-volume water extraction across remote job sites demands powerful dual-motor suction and overseas power compatibility. The NaceCare Solutions WVD 1802DH K-8026610 matches a 220/240 Volt dual-motor 1600W powerhead with an internal continuous discharge pump. The total dry weight exceeds 85 pounds, requiring substantial muscle to lift onto elevated truck beds.

The dual-motor powerhead houses two independent 800W peripheral bypass motors wired for high-voltage European or marine industrial power. Structofoam structural resin creates an indestructible 20 Gallon container that rejects denting from shop impacts and caustic chemical baths. Inside the base, a heavy-duty submersible water pump ejects incoming liquid continuously under head pressure through a dedicated hose fitting. Mechanical ball bearings and dynamic motor balance protect the rotating assembly from premature failure under vibration.

Continuous Marine Hardware Matrix

Marine engineers and industrial technicians deploy this high-voltage continuous-pumping vacuum for rapid bilge and tank draining. Mechanical float components automate water clearance without electronic board failures.

• 220/240 Volt electrical architecture pulls 7.2 Amps for stable operation on heavy marine generators
• Internal continuous pump evacuates water through a garden hose fitting as fast as it enters
• 20 Gallon Structofoam drum resists corrosion from saltwater, coolants, and floor degreasers
• 1600W dual-motor system delivers 160 CFM of airflow and 90-inch static water lift
• C3A toolkit includes industrial metal wands, floor tools, and heavy-duty hose couplings
• Dump hose assembly allows rapid manual gravity drainage when discharge pump is not required
• Sturdy steel transit cart with large rear wheels manages threshold crossings without hang-ups

High-Voltage Thermal Bench Data

Electrical draw stabilizes at 7.2 Amps across 230 Volt power inputs with both vacuum motors and the pump running. Powerhead shell temperatures rise 41°F above room ambient after 50 minutes of loaded liquid extraction. Motor cooling discharge air peaks at 120°F under sustained sump evacuation work. Vacuum line drop measures 7-inch water lift across a standard 12-foot suction hose. Acoustic testing logs 72 dBA at 10 feet, climbing to 75 dBA under dual-motor continuous pumping.

Operational Realities Upkeep Directives

The steel cart rolls over deck coamings easily, but moving this unit up steep ship ladders requires crane hoists. Remediation teams operating on standard domestic 120 Volt circuits must avoid this high-voltage model due to direct electrical incompatibility. Processing plaster dust, masonry slurry, or thick sand will seize the submersible pump impeller and cause thermal tripping.

• Rinse the internal sump pump screen with fresh water following all saltwater extractions
• Inspect high-voltage cable insulation weekly for cut hazards around metal hatchways
• Lubricate cart axle sleeves every six months using water-resistant marine grease

Factory Warranty Package Inventory

NaceCare backs this machine with a 2-Year motor warranty and a 10-Year tank replacement warranty. The carton contains the 220/240 Volt dual-motor head, 20 Gallon Structofoam tank, continuous internal pump, C3A commercial toolkit, drain hose, and operational documentation.