Greenlee Wire Dispenser

Description

National Electrical Code standards demand organized conductor management on commercial rough-in jobsites using the Greenlee 909 Wire Dispenser Caddy hand unit. Built to hold single branch wire spools, this all-steel caddy dispenses conductors without spool tangles. Welded tubing withstands rough handling. Small base feet can tip over under violent off-angle line pulls.

Formed 1in diameter ASTM A36 tubular steel makes up the welded triangular frame, coated in durable green enamel paint. A single 5/8in solid steel axle pin supports spools up to 20in diameter and 12in wide, bearing 100 lbs total capacity. The compact base uses non-skid rubber feet to isolate steel from concrete decks. Unboxed tool weight measures 12 lbs, with storage stance measuring 22in long by 15in wide by 18in high in electrician vans.

Key Features of Greenlee 909

Residential and commercial electricians buy Greenlee 909 dispensers to pull single branch circuits without unspooling wire messes across floor decks. Low acquisition pricing provides dependable jobsite wire payoff without storing bulky rolling carts inside small service vans.

• Heavy-duty 1in tubular steel frame supports wire reels weighing up to 100 lbs.
• Solid 5/8in steel axle bar holds branch wire spools up to 20in diameter.
• Quick-release spring clips allow spool changes in under 30 seconds without tools.
• Non-skid rubber feet prevent the dispenser from sliding across slick concrete decks.
• Angled frame geometry prevents wire overrun and birdnesting during fast hand pulls.
• Integrated carry handle allows 1-hand transport across multistory jobsites.
• Compact 12 lbs weight stores flat on service van shelving units between jobs.
• Baked enamel green finish protects raw steel against corrosion from rain and mud.

Axle Payout Bench Benchmark

Static weight testing confirms the 5/8in solid steel axle bar carries 100 lbs of spool weight without center pin deflection or frame sag. The welded triangular base resists 180 lbs of vertical drop force onto concrete without seam cracking. Spool payout testing confirms reel rotation without bind against 15 lbs of continuous wire pulling tension. Non-skid rubber feet resist 35 lbs of horizontal skid pull on broom-finished concrete. Baked enamel coating withstands 400 hours of salt fog exposure without corrosion.

Jobsite Floor Usability Bounds

Carrying the 12 lbs steel dispenser with a full 50 lbs wire spool takes minimal effort using the top steel handle. Do not pull wire from this caddy at angles greater than 45 degrees from center because lateral line tension will tip the light triangular frame over on smooth slabs.

• Inspect the 5/8in steel axle pin and frame welds for bends or cracks every 60 days.
• Wipe axle bar clean and apply light silicone spray to stop payout squeaks every 30 days.
• Check rubber foot pads for wear and replace worn feet to prevent floor scratching.

Factory Warranty Crate Manifest

Greenlee covers the 909 wire dispenser with a 1-Year commercial warranty against material defects and workmanship flaws. The packaging carton holds the welded triangular frame, 5/8in steel axle bar, spring retention hitch pins, rubber feet, and complete equipment setup instructions.