SKILSAW 16-5/16 In. Magnesium Super Sawsquatch Worm Drive Saw

Description

Standard worm drive saws lack the cutting depth required to notch heavy structural timber posts in one pass. The SKILSAW 16-5/16 In. Magnesium Super Sawsquatch Worm Drive Saw delivers massive timber cutting muscle with a 15-ampere motor spinning a 16-5/16-inch blade at 2500 RPM. This 30-pound timber saw requires two-handed operator control and cannot perform delicate flush trimming.

A precision-machined brass worm gear meshed with a hardened steel worm shaft transfers extreme rotational torque to the 1-inch arbor without drive slippage. Cast magnesium construction for the motor housing, gear frame, and foot plate keeps tool weight manageable during timber framing. Heavy deep-groove ball bearings support the heavy carbon steel arbor shaft, while an integrated electric blade brake brings the massive steel blade to a halt rapidly.

Super Sawsquatch Timber Matrix

A massive 6-1/4-inch cutting depth capacity handles 6×6 dimensional lumber and thick timber posts in a single pass. The Dual-Field motor design features advanced copper winding geometry that dissipates heat under continuous loads.

• 15-ampere Dual-Field motor pairs with brass worm drive gearing to deliver 2500 RPM blade speed
• 16-5/16-inch carbide blade cuts 6-1/4-inch lumber at ninety degrees and 4-5/16-inch at forty-five
• Cast magnesium construction minimizes total tool weight while maintaining structural rigidity
• Electric blade brake halts the large 16-5/16-inch blade rapidly for increased operator safety
• Precision worm drive gearing delivers high rotational torque through demanding timber cuts
• Bevel capacity tilts fifty-six degrees with positive stops at zero and forty-five degrees
• Auxiliary front handle provides balanced two-handed control during deep timber framing cuts

Shop Dyno Worm Telemetry

Dynamometer testing on a 120-volt 20-amp line records 14.9 amperes continuous current draw while cutting 6×6 treated hemlock timbers. Arbor rotational speed settles at 2380 RPM from a 2510 RPM free-spin baseline under steady feed pressure. Arbor runout measures less than 0.0014 inches total indicator reading. Worm drive oil bath temperature rises 36 degrees Fahrenheit after ten continuous 6×6 timber cuts. Sound pressure outputs 95 dBA at operator position.

Maintenance Protocols Timber Bounds

This massive worm drive timber saw requires regular gear oil inspections to prevent brass worm gear wear under severe friction loads. Framing crews should not use light 16-gauge extension cords because voltage drop will overheat the high-draw Dual-Field motor. Avoid dropping the magnesium foot plate onto hard surfaces to prevent bending the depth adjustment bracket.

• Inspect worm drive gear oil level through the sight plug every fifty hours of timber cutting use.
• Blow fine sawdust from the lower blade guard pivot mechanism using dry shop compressed air.
• Check arbor bolt torque with the supplied wrench before starting heavy timber beam cutting.
• Wipe resin buildup from the magnesium foot plate using solvent to maintain smooth sliding.
• Inspect carbon motor brushes every one hundred operating hours and replace if worn down.

Factory Warranty Tool Manifest

SKILSAW provides a 1-Year limited warranty covering worm drive gear components and electrical motor assemblies. The tool package includes the 16-5/16-inch Super Sawsquatch worm drive saw, 16-5/16-inch 32-tooth carbide blade, auxiliary handle, blade wrench, saw stand bracket, and instruction manual.