Fein Ampshare Multimaster Multi-Tool 700 Max Top Set 18V 4Ah 68pc

Description

Torque drop and excessive hand vibration during plunge cuts fatigue operators and slow down restoration jobs. The Fein Ampshare Multimaster Multi-Tool 700 Max delivers aggressive oscillating power with a heavy-duty brushless motor producing 19500 oscillations per minute. This industrial oscillating tool requires heavy AmpShare batteries and will overheat standard accessory blades if run at maximum speed on metal bolts.

The mechanical drive utilizes a self-supporting brushless motor decoupled from the outer housing via four elastomeric vibration dampers to suppress hand shock. A full-metal gearbox houses case-hardened steel drive gears and ball bearings that endure continuous lateral torque loads. The patented StarlockMax tool mounting interface transfers drive motor torque with zero play across accessory blades, preventing drive slip and collar wear during heavy plunge cuts.

Oscillating Multi-Tool Hardware

A wide 2×2.0-degree oscillation amplitude clears wood chips rapidly during deep plunge cutting tasks. The StarlockMax clamp system allows three-second blade changes without touching hot metal accessories.

• Commercial brushless motor generates 10000 to 19500 oscillations per minute with constant speed electronics
• StarlockMax direct-contact interface delivers one hundred percent mechanical torque transfer to blades
• Anti-vibration decoupling architecture isolates motor resonance from the glass-reinforced outer shell
• QuickIN tool-free lever clamp secures cutting accessories tightly in less than three seconds
• Full metal drive head withstands extreme lateral forces during continuous mortar and timber cutting
• AmpShare 18-volt battery platform shares cross-brand compatibility with professional Bosch tool packs
• Electronic tachometer circuitry maintains selected oscillation frequency under severe cutting loads

Vibration Bench Telemetry Telemetry

Dynamometer and vibration bench measurements confirm a 2×2.0-degree oscillating angle under high mechanical resistance. Loaded oscillation speed stabilizes at 19100 OPM under full motor throttle. Vibration feedback to the handle measures an ultra-low 1.2 meters per second squared due to internal rubber isolation mounts. Drive head casing temperature rises 31 degrees Fahrenheit after ten minutes of continuous grout removal. Acoustic sound emissions peak at 83 dBA at maximum speed.

Field Care Rules Tool Limitations

This oscillating machine requires genuine StarlockMax or StarlockPlus accessories to prevent interface shearing under heavy motor loads. Tradesmen should not apply excessive downward pressure during deep plunge cuts because friction heat will anneal and destroy blade teeth. Avoid running without clearing the QuickIN clamping lever mechanism of abrasive drywall dust.

• Blow fine drywall and mortar grit from the mechanical QuickIN clamp head using dry compressed air.
• Apply a light drop of machine oil to the steel clamping pin every fifty tool change cycles.
• Inspect AmpShare battery terminal contacts for corrosion and clean with electrical cleaner spray.
• Select lower electronic speed dials when scraping delicate adhesive layers to avoid burning base surfaces.
• Store cutting accessories inside dry plastic cases to protect sharp carbide and bi-metal tooth edges.

Commercial Warranty In-Box Contents

Fein supports this professional kit with a 3-Year limited warranty upon online product registration. The 68-piece package contains the Multimaster 700 Max tool, two 18-volt 4.0Ah ProCORE batteries, rapid charger, 60-piece accessory blade and sanding set, dust extraction adapter, plastic storage case, and manual.