Dake Dake V-26 220V 3 Phase Manual Feed 26 Inch Throat Vertical Bandsaw

Description

Driving a continuous band blade through alloy plate, the Dake V-26 26 Inch Vertical Bandsaw cuts contours and blanking dies with high precision. A 3HP 3PH motor runs on 220V power to drive a 26in throat mechanism. This 1,650 lbs machine anchors to concrete floors, requiring dedicated three phase electrical power drops.

Heavy cast iron and thick welded steel plate construct the vertical column, lower base, and work table. The 3HP three phase motor draws 8.6 FLA at 220V, driving an enclosed four-speed gearbox with variable frequency control from 50 to 4,500 FPM. Base floor stance measures 48in long by 42in wide. A ground cast iron work table measures 26in by 26in on the shop floor.

Key Features of Dake 987031

Tool and die manufacturing plants buy Dake 987031 vertical bandsaws for complex internal die profiling. Machine shop supervisors evaluate commercial vertical contour bandsaw pricing to secure continuous cutoff torque across tool steels and non-ferrous plates.

• The 3HP 3PH motor sustains high low-end torque for hogging thick tool steel blocks.
• Deep 26in throat capacity accommodates wide plates and structural sheet contouring.
• Variable blade speed adjusts from 50 to 4,500 FPM for cutting various alloy hardnesses.
• Onboard resistance blade welder and grinder station splices bulk coil stock at the machine.
• Cast iron table tilts 45 degrees right and 10 degrees left for compound angle cuts.
• Roller bearing blade guides prevent lateral deflection during tight radius contouring passes.
• Integrated chip blower nozzle keeps layout lines clear of metal filings during cutting.

Dynamic Spindle Tolerances Load Metrics

Wheel rim runout tests measure under 0.0004in TIR across both upper and lower cast wheels. Blade speed drops less than 2 percent under heavy hand feed on 3in thick D2 tool steel blocks. Motor current stabilizes at 7.8 FLA on 220V circuits, with motor frame temperatures rising 31°F above room ambient after 5 hours of continuous contour cutting. Cast table surface flatness stays true within 0.003in. Operating sound reads 75 dB during alloy plate cutting passes.

Table Tilt Mechanics Preventative Service

Table tilt handwheels lock with 12 lbs torque applied to the cast locking levers without slipping under heavy stock loads. Do not buy this machine for lightweight wood craft trimming, 115V single phase outlets, or unbolted shop benches. Maintain mechanical cutting accuracy through structured maintenance routines.

• Clean metal chips and filings from lower wheel compartments every 20 operating hours with dry air.
• Inspect blade guide roller bearings every 50 hours and replace scored guide rollers.
• Lubricate blade tension screw threads every 90 days using ISO 68 machine oil.

Dake Factory Warranty Packaging Manifest

Dake covers this vertical bandsaw with a 1-Year commercial warranty on parts against defects. The wooden shipping crate houses the V-26 saw assembly, bi-metal blade, onboard blade welder, grinder station, chip blower hose, work lamp, tool kit, hardware pack, and comprehensive machine operating manual.