Star Water Systems Well Pump 2 Wire 10gpm 1hp 230V

Description

Deliver dependable potable water pressure from deep underground residential aquifers. The Star Water Systems Well Pump 2 wire submersible pump supplies steady domestic volume from deep casings. A 1.0-horsepower continuous-duty motor turns multiple floating thermoplastic impellers. The 2-wire design means you cannot install an external control box above ground.

Corrosion-proof 304 stainless steel forms the outer shell, motor casing, and splined drive shaft. Glass-filled polycarbonate impellers resist abrasion from fine underground sand grains. A built-in stainless steel check valve prevents water column backflow down the well pipe. Hermetically sealed motor windings run in non-toxic dielectric fluid for maximum heat dissipation. The discharge head features rugged cast stainless steel.

Submersible Well System Details

Well technicians install deep water lift systems without complex external starting components. The 2-wire setup routes straight from the pressure switch down to the pump motor.

• Continuous-duty 1.0-horsepower motor operates on standard 230-volt single-phase residential power
• Multi-stage floating impeller group delivers 10 GPM from depths down to 250 feet
• Corrosion-proof 304 stainless steel shell resists harsh mineral scale buildup
• Built-in check valve stops water hammer damage on external plumbing pipes
• Glass-filled polycarbonate stages resist abrasion wear from underground silica sand
• Integrated suction screen blocks gravel particles larger than 0.08-inch diameter
• Standard 1.25-inch NPT discharge connects straight to schedule 80 drop pipe

Hydrodynamic Dyno Load Telemetry

Dynamometer testing confirms the electric motor draws 8.2 Amps on 230-volt circuits under a 200-foot total dynamic head. Water discharge stabilizes at 10.4 GPM into pressurized bladder tanks. Motor winding temperatures stabilize at 128°F within flowing 55°F well water. The internal thrust bearing endures 750 pounds of downthrust during continuous deep-well pumping runs.

Field Application Operator Boundaries

You lower this pump down 4-inch well casings using a dedicated safety torque cable. The smooth stainless steel shell slides past casing joints without snagging. Do not run this pump inside dry well casings without water cover. Operating the motor without fluid flow causes rapid thermal expansion that destroys the stator windings.

• Install a dedicated check valve on the drop pipe every 100 vertical feet
• Test motor electrical insulation resistance with a megohmmeter before dropping well pipes
• Secure electrical drop wires to the pipe with waterproof tape every 10 feet

Commercial Warranty Specifications Manifest

Star Water Systems provides a 3-Year limited warranty covering pump and motor components. The shipping box contains the 1.0-horsepower 2-wire pump, integrated check valve, splice kit, and complete well installation guide.