JET JWP-208-1 20 In. 3 HP 1Ph Planer

Description

Need dependable wide board planing on standard 230V utility power? The JET JWP-208-1 20in Wood Planer surfaces hardwood stock up to 20in wide with a 3HP single-phase motor. The cutterhead uses traditional high-speed steel straight knives, requiring careful knife height setting whenever blades undergo sharpening or replacement.

Meehanite gray cast iron creates the solid machine base, table, and cutterhead support columns, deadening harmonic vibration during wide passes. The 3HP motor runs on 230V single-phase power, drawing 15 FLA while spinning the four-knife cutterhead at 5,000 RPM. This stationary wood planer covers a floor stance of 37in by 26in and weighs 660 lbs.

Key Features of JET JWP-208-1

Cabinetmakers and custom woodworkers buy JET JWP-208-1 machinery to surface wide panels and rough lumber without three-phase electrical connections. Equipment pricing reflects the combination of a 20in width capacity, dual-speed gearbox, and heavy cast iron construction.

• A ground 20in by 25.75in cast iron table provides smooth, low-friction support for heavy hardwood planks.
• The 3HP single-phase motor operates on common 230V electrical service without requiring phase converter units.
• A four-knife high-speed steel cutterhead delivers 20,000 cuts per minute for smooth board finishes.
• The two-speed gearbox shifts feed rates between 16 FPM and 20 FPM to match stock grain density.
• Serrated steel infeed and smooth polyurethane outfeed rollers maintain steady stock feed through cuts.
• Large handwheels adjust table elevation smoothly, with one full turn yielding 0.059in bed movement.
• A 5in dust port connects to shop dust collection ducts to remove wood shavings efficiently.

Dynamic Load Checks Runout Accuracy

Bench indicator testing confirms radial cutterhead runout stays inside 0.0004in TIR across the shaft span. Planing an 18in wide cherry board at 0.090in depth of cut causes less than 0.0008in bed deflection. The 3HP motor draws 12.8A under continuous load. Operating noise meters register 82 dB during straight-knife cutting, with cutterhead bearings reaching 112°F.

Operator Interface Routine Upkeep Boundaries

The cast iron table handwheel requires 5 lbs rim effort to lift the heavy machine bed. The feed rate shift knob engages gears with 4 lbs hand effort. Do not buy this single-phase planer for high-production multi-shift factories running continuous daily cycles.

• Sharpen or replace high-speed steel knives and reset knife projection using the setting gauge every 50 hours.
• Check feed roller drive chain tension and lubricate with SAE 30 oil every 40 hours of use.
• Clean pitch and resin from the cast iron table bed and apply paste wax every 8 hours.

Warranty Statement Machine Delivery Inventory

JET backs this stationary wood planer with a 2-Year limited warranty against defects in craftsmanship and parts. The factory shipping crate contains the 20in planer assembly, four-knife cutterhead, knife setting gauge, dust collection hood, structural steel base, and instruction manual.