Husqvarna Construction DMS 180 Core Drill Rig 2.5 Hp 15 A 1 Phase 60 Hz 100-120 V

Description

Water wash-out and motor drag stall core drilling rigs on cured concrete job sites. The Husqvarna Construction DMS 180 Core Drill rig delivers steady wet drilling through concrete and asphalt at 800 RPM. Motor output delivers 2.5 horsepower. Rig anchor movement ruins diamond bit segments if anchor bolts loosen during high torque slab penetration.

The gearbox features oil-bath lubricated spur gears cut from high-tensile alloy steel to survive extreme continuous torque. A mechanical slip clutch protects internal gear teeth whenever diamond barrel teeth snag steel rebar. Precision ball bearings support the water-cooled spindle shaft. Ductile iron base castings prevent rig column flex under heavy downforce while phenolic composite seals keep high-pressure slurry out of the motor housing.

Hardware Performance Matrix Breakdown

Precision core drilling requires stable column mounting and steady water feed through the spindle. Mechanics track these specific hardware points to maintain continuous diamond coring production.

• 2.5 horsepower electric drive motor provides continuous spindle torque to cut seven-inch diameter holes.
• 800 RPM single speed rotation turns diamond core barrels at optimum peripheral cutting speed.
• Integrated water swivel injects cooling water through diamond bits to wash out abrasive slurry.
• Mechanical slip clutch disengages drive gears during core bit bind to prevent gear tooth shear.
• Rigid steel column resists bending forces during aggressive hand crank downfeed pressure.
• Cast aluminum base plate anchors to concrete floors using standard expansion bolts or vacuum suction.
• Built-in ground fault circuit interrupter cuts electrical power upon sensing stray current leakage.

Dyno Bench Load Telemetry

Air bench dynamometer equivalence requires 65 CFM at 90 PSI dynamic under full coring load to duplicate spindle performance. Spindle free speed hits 800 RPM but loaded stone cutting drags rotation down to 610 RPM. Compressed air lines experience an 18 PSI dynamic pressure drop through restrictive 3/8-inch couplers. Adiabatic exhaust expansion drops exhaust temperatures by 34 degrees Fahrenheit which freezes moisture traps and sintered bronze exhaust mufflers. Breakaway torque reaches 62 foot-pounds with acoustic levels registering 88 dBA during continuous stone penetration.

Field Service Trade Offs

Anchoring this rig requires solid substrate bolting because loose mounting shatters expensive diamond barrel segments. Contractors operating light utility air setups or undersized portable generator packs should not buy this unit because high amp draw trips small circuit breakers during deep structural foundation coring.

• Flush water swivel seals with clean fresh water after every coring job to remove slurry grit.
• Grease the column guide rollers and rack teeth before starting deep aggregate boring passes.
• Inspect ground fault interrupter cords for jacket cuts before connecting power cables to jobsite outlets.

Commercial Warranty Terms Inventory

The core drill unit includes a 1-Year limited warranty against structural and mechanical manufacturing defects. The factory unboxing container includes the drill motor, anchor column stand, integrated water swivel valve, column mounting base, feed crank handle, spindle wrench set, and an industrial operating guide.