Shop Fox 13-1/4in Oscillating Benchtop Drill Press

Description

Combining contour spindle sanding and vertical hole boring on one compact bench footprint saves small woodshop floor space. The Shop Fox Oscillating Bench Drill Press clears 13-1/4-Inch workpieces using dual-action motor power. You swap drums by hand. The rotary oscillation mechanism requires manual lock-out before drilling deep mortises to prevent vertical spindle stroke wandering.

Heavy gray cast iron forms the slotted tilting table and bench base, damping machine harmonics during high-speed sanding runs. A 3/4-HP induction motor connects to standard 110V 1-Phase outlets, drawing 8.6 full-load amps to drive 12-Spindle speeds from 250 to 3050 RPM via stepped V-belts. The 2-3/4-Inch ground steel column supports the worktable. The benchtop machine weighs 122 lbs, measuring 23 inches deep by 14 inches wide across its shop footprint.

Key Features of Shop Fox Oscillating

Woodworkers and luthiers buy Shop Fox oscillating drill presses to drill holes and sand curved contours on one machine. The oscillating motion moves sanding drums up and down to prevent heat burns on delicate timber.

• Dual-function 3/4-HP induction motor powers standard hole drilling and rotary contour sanding.
• Oscillating spindle stroke moves up and down 3/4-Inch to prevent paper clogging.
• Stepped V-belt transmission provides 12-Spindle speeds ranging from 250 to 3050 RPM.
• Half-inch keyed drill chuck seats twist drill bits and standard sanding drum arbors.
• Heavy cast iron table tilts 90-Degrees for bevel hole boring and angled edge sanding.
• Table insert plate allows sanding drums to dip below the table surface.
• Front paddle safety switch includes a removable lockout key to prevent accidental tool startup.

Oscillating Spindle Bench Test Metrics

Precision dial indicator tests verify total indicated runout (TIR) measures under 0.0012 inches at the drill chuck arbor in stationary drilling mode. The oscillating mechanism delivers 29 vertical strokes per minute at 3/4-Inch stroke length during active sanding cycles. Driving a 1-Inch Forstner bit through rock maple drops spindle speed from 540 free RPM to 518 loaded RPM under manual downfeed. Spindle bearing temperatures remain below 118 degrees Fahrenheit after 45-Minutes of continuous wood sanding tests on bench test stands.

Shop Floor Handling Field Service

The three-spoke feed wheel gives you steady mechanical downfeed control across the entire 3-1/4-Inch quill stroke. Skip this light machine for heavy structural steel production drilling. The oscillating mechanism lacks the rigid lockup required for 1-Inch steel twist drills, and stepped pulleys require manual belt changes. Bolt the benchtop base down firm to your workbench before running heavy timber.

• Clear wood sanding dust out of the lower oscillating drive gearbox every 3-Months.
• Wipe the precision ground cast iron table with paste wax monthly to block rust.
• Check V-belt tension quarterly and adjust motor bracket tension levers to stop slip.

Factory Warranty Standard Crate Manifest

Shop Fox backs this oscillating drill press with a 2-Year commercial warranty covering manufacturer defects. The crated factory package delivers the bench machine, 5/8-Inch keyed drill chuck, arbor key, three rubber sanding drums, sanding sleeves, a table insert, and an illustrated operator instruction manual.