Ridgid K-1500B Sectional Machine with A-1 Mitt A-12 Pin Key and Rear Guide Hose

Description

Cast aluminum and hardened alloy steel give the Ridgid K-1500B Sectional Sewer Machine the strength to scour municipal sewer mains out to three hundred feet. This 120-volt machine spins 1-1/4-inch sectional cables at seven hundred RPM to chop heavy tree roots. It clears two-inch to ten-inch lines. Sectional cables feed by hand.

The frame utilizes a rugged tubular steel cart mounted with corrosion-resistant cast aluminum gear housings. A 3/4-HP, 120-volt capacitor-start induction motor pulls 10.4 full-load amps, spinning drive clutch jaws at seven hundred RPM. The machine chassis weighs 135 lbs, measuring 24 inches long by 19 inches wide on ten-inch solid rubber cart wheels. Its upright handcart design wheels over curbs and stairs.

Key Features of Ridgid K-1500B

Commercial drain cleaning contractors buy Ridgid K-1500B machines to tackle massive commercial root jobs without dragging heavy drums across landscaped lawns. Industrial sewer machine pricing delivers high-speed clutch drive power that clears blockages out to three hundred feet inside heavy municipal laterals.

• Instant-acting clutch engages cable spin without hesitation when pushing the handle down.
• High-torque 3/4-HP motor spins sectional cable at seven hundred RPM for fast root cutting.
• Sectional cable system allows one worker to carry equipment into buildings piece by piece.
• Rear guide hose contains cable whip to protect operator clothing and surrounding walls.
• Heavy tubular steel cart rolls across rough lawn terrain on large solid wheels.
• Standard A-1 operator mitt protects hands while feeding rotating sectional cable into drains.
• Includes A-12 coupling pin key for fast disconnect of cable sections and tool heads.

Clutch Drive Bench Test Calibration

Bench dynamometer testing verifies the clutch jaw delivers two hundred ten foot-pounds of rotational torque before slip occurs on C-11 cable. Spindle rotation stabilizes at seven hundred free RPM, dropping less than six percent under heavy simulated root resistance. The clutch release lever stops cable spin within 0.08 seconds of release, eliminating dangerous cable overrun. Motor casing temperature climbs twenty-eight degrees Fahrenheit across forty-five minutes of continuous heavy load running. Rear guide hose clamps show zero looseness under maximum cable whip.

Sewer Usability Scheduled Maintenance Directives

The upright cart wheels let plumbers tilt and roll the power unit across rough gravel yards. Feeding cable sections requires positive grip with the leather mitt. However, do not purchase this 1-1/4-inch sectional machine for small 1-1/2-inch sink lines, tight residential cleanouts, toilet traps, or roof vents.

• Flush clutch jaws with degreaser and clean water after every messy root job.
• Inspect cable coupling lock pins once a week for wear, burrs, or spreading.
• Grease main drive shaft grease fittings every fifty hours of sewer operation.

Factory Warranty Machine Manifest

Ridgid backs this sewer machine with a Lifetime warranty covering manufacturing flaws and structural casting defects. The factory crate includes the K-1500B machine on wheel cart, rear guide hose, A-1 operator mitt, A-12 pin key, and official technical operator manual. Cables and cutters require separate purchase.