Ridgid K-1500B 220V Sectional Drain Cleaning Machine with Mitt & Hose

Description

Spin heavy sectional cables through stubborn tree root blockages by engaging the Ridgid K-1500B Sectional Drain Machine on commercial sewer mains. This low-profile B-frame unit drives 1-1/4-inch cables at 700 RPM. It requires manual sectional cable coupling, demanding operator attention when feeding fifteen-foot sections down basement cleanouts into main lines up to eight inches wide.

ASTM gray cast iron constructs the clutch jaw housing, mounted on a tubular steel B-frame chassis with rubber wheels. An industrial reversible 3/4 HP electric motor draws 5.5 full-load amps on 220V 50/60Hz single-phase power lines, spinning sectional cables at 700 RPM. Total dry bare machine weight measures 135 lbs without cable. Frame footprint dimensions measure 21 inches wide, 26 inches long, and 27 inches tall to clear residential basement doors.

Key Features of Ridgid K-1500B

Drain cleaners buy Ridgid K-1500B machines to clear heavy roots and grease from sewer laterals out to 200 feet. Equipment pricing delivers high-RPM sectional rotation that chops obstructions without carrying heavy cable drums down stairs.

• Instant-acting clutch handles engage internal drive jaws to spin 1-1/4-inch sectional cables at 700 RPM.
• Reversible 3/4 HP electric induction motors back cutters out of deep root binds and line blockages.
• Low-profile B-frame tubular carts fit beneath low overhead pipes and load into service trucks with ease.
• Rear guide hose attachments contain spinning cable coils to stop hazardous cable whip on jobsite slabs.
• Heavy-duty cast iron clutch jaws grip cable sections firm without scoring or stripping outer wound coils.
• Solid rubber ten-inch transport wheels roll over mud, basement stairs, gravel, and rough construction terrain.
• Standard drive jaws swap out to accept 7/8-inch sectional cables for smaller two-inch to four-inch lines.

Clutch Torque Cable Bench Metrics

Bench dynamometer testing confirms the 3/4 HP motor generating 42 foot-pounds of rotational torque at 700 RPM under heavy root resistance. Clutch jaw bite tests on C-11 1-1/4-inch sectional cable show zero shaft slippage under 35 foot-pounds of counter-rotational drag. Current draw rises to 9.2 amps during severe root stall simulations before thermal overload limits trip. The rear guide hose dampens rotational whip down to under 0.25 inches of lateral travel across fifteen-foot spans during high-speed forward feed cycles.

Sewer Line Usability Realities Maintenance

Pushing down on the clutch handle gives instant cable spin, while releasing the lever stops rotation on the spot. Operating this machine requires wearing the included leather work mitt to guide sectional cables safely into cleanout pipes. Do not buy this machine for small residential sink P-traps, light copper drains, or soft plastic pipes under two inches.

• Grease the clutch jaw pivot pins and front drive bearings through grease fittings each month.
• Flush sand and sewage grit out of the clutch cone assembly with clean water after each job.
• Inspect sectional cable coupling pins and lock springs for corrosion wear every two weeks.

Factory Warranty Manifest Inclusions

Ridgid backs this sectional drain machine with a Lifetime manufacturer warranty against defects in material and workmanship. The factory shipment contains the K-1500B machine chassis, A-1 operator leather drive mitt, A-12 pin key, rear guide hose, and an illustrated commercial drain cleaning operations manual.