Ridgid 4-6in x 6′ Pipe Patch Repair Kit

Description

Why excavate finished basement concrete when structural point repair seals cracked pipes underground? The Ridgid Pipe Patch Repair Kit restores broken 4-inch to 6-inch lines across six-foot sections using ambient-cure silicate resin. Technicians must work without delays. Chemical resin pot life limits the wet-out and packing window to fifteen minutes before uncontrollable hardening locks the fiberglass mat.

Multiaxial fiberglass fabric forms the structural composite sleeve, delivering high ring stiffness without adding pipe wall thickness. Two-part organomineral silicate resin bonds the woven glass fibers under ambient pipe temperatures without external steam boilers. Silicone outer stretch wrap protects expanding packer rubber during line insertion. The complete boxed kit scales at 18 lbs, measuring 76 inches long by 8 inches wide to protect pre-cut six-foot fiberglass rolls during transit to jobsites.

Key Features of Ridgid Pipe Patch Kit

Trenchless repair contractors buy Ridgid Pipe Patch Kit packages to seal root-invaded joints without digging up commercial parking lots. The cured-in-place structural sleeve restores line integrity within two hours while maintaining smooth interior hydraulic flow.

• Multiaxial E-glass fabric creates a six-foot structural sleeve inside cracked 4-inch to 6-inch pipes.
• Two-part silicate resin cures in moist underground environments without external heat or UV lamps.
• Ambient chemical formula provides a predictable fifteen-minute wet-out pot life at 68 degrees Fahrenheit.
• Thin composite profile preserves over ninety-five percent of original pipe internal diameter and water flow.
• Transparent vacuum containment tube prevents resin mess and resin loss during jobsite wet-out steps.
• Pre-measured chemical packs eliminate field mixing calculation errors to secure proper composite curing strength.
• Heavy silicone stretch wrap secures the patch onto mechanical packers during lateral pushrod navigation.

Hydrostatic Pressure Bench Test Metrics

Bench pressure tests prove the cured silicate fiberglass sleeve withstands 45 PSI of internal hydrostatic pressure after a 90-minute cure at 65 degrees Fahrenheit. Cured laminate thickness measures 0.160 inches across the four-inch diameter test specimen, showing zero ring deflection under 1200 lbs of external crush load. Exceeding the 15-minute resin work window causes severe fiber dry-spots, cutting structural adhesion to host clay pipes by forty percent. The smooth internal composite finish maintains an ultra-low hydraulic roughness coefficient of 0.009 Manning value.

Field Usability Jobsite Operational Constraints

The slender shipping tube lets one technician carry this patch kit down narrow staircases into commercial basements. Do not use this kit on pipe bends exceeding forty-five degrees. The rigid six-foot fiberglass wrap will wrinkle and block packer expansion inside tight sweep elbows. Spreading resin requires chemical-resistant nitrile gloves, safety goggles, and firm roller pressure on a flat tabletop.

• Store resin bottles between 50 and 80 degrees Fahrenheit to prevent chemical separation.
• Hydro-jet and camera inspect the host pipe prior to patch insertion to remove mineral scale.
• Depressurize the expansion packer only after confirming resin cure through test ring hardness.

Factory Warranty Standard Kit Manifest

Ridgid guarantees all unmixed chemical components and fiberglass sleeves with a 1-Year shelf warranty from the ship date. The kit package contains a pre-cut six-foot fiberglass mat, resin Part A and Part B, mixing spatulas, protective table plastic, work gloves, and an installation manual.