Exact Tools PipeCut P400 18V 5Ah Battery Powered Pipe Saw Kit

Description

Sever and bevel thick plastic drainage pipe with the Exact Tools PipeCut P400 Saw Kit on rough excavation beds. This cordless system cuts plastic pipes from 4 inches up to 16 inches in diameter in one pass. It eliminates uneven cuts from reciprocating saws. The motor carriage requires manual hand pressure to feed around the pipe exterior.

Die-cast aluminum forms the chassis body and pipe roller carriage to reduce carry weight across muddy trenches. An eighteen-volt DC brushless motor couples to heavy steel drive gearing, drawing twenty-four full-load amps under deep plastic wall penetration. Tool weight measures 15.4 lbs without roller supports, expanding to 38 lbs with accessories in tow. The saw body dimensions span 17.5 inches long by 11.2 inches wide.

Key Features of Exact PipeCut P400

Underground utility crews buy Exact PipeCut P400 kits to accelerate trench pipe prep without running generator cords. Commercial pipe saw pricing reflects heavy industrial components made to resist abrasive slurry and dirt.

• Roller carriage wraps around pipes up to sixteen inches outside diameter for true square cuts.
• Simultaneous cut and bevel blade preps PVC pipe ends for push-fit gaskets in seconds.
• Brushless eighteen-volt motor maintains high torque through one-inch thick plastic walls without stalling.
• Integrated vacuum port hooks up to dust extractors to clear dangerous PVC micro-particles.
• Battery fuel gauge monitors remaining charge during remote utility trench pipe installations.
• Heavy aluminum guide wheels grip pipe surfaces without slipping on wet mud coatings.
• Quick-clamping latch locks the saw carriage onto pipe circumferences without extra tools.

Blade Runout Trench Feed Metrics

Bench dial indicators show arbor runout under 0.0008 inches at four thousand free RPM. Under load on twelve-inch SDR-35 PVC pipe, blade speed drops five percent from baseline while drawing fifteen amps. The cut face maintains perpendicular squareness within 0.030 inches across the entire pipe circumference. Motor housing temperature rises twenty-four degrees Fahrenheit after four back-to-back cuts through dense polyethylene walls. The plastic bevel width holds consistent at 0.59 inches around the full pipe perimeter without chatter.

Excavation Handling Field Service Realities

The top carry handle centers tool balance during positioning inside tight trench boxes. Clamping the roller carriage around wet pipe requires two hands for correct tracking. Do not purchase this pipe saw kit for ductile iron, structural steel pipe, or spiral metal duct fabrication.

• Clean grit from carriage roller bearings after every workday using clean compressed air.
• Inspect the carbide bevel teeth once a week for chipped edges or thermal wear.
• Blow PVC dust accumulation out of motor intake louvers after every trench shift.

Factory Warranty Kit Manifest

Exact Tools covers this saw with a 1-Year warranty against material defects and electrical drive failures. The complete kit includes the P400 pipe saw, TCT 150 cut-and-bevel blade, two 18V 5Ah lithium batteries, quick charger, four pipe roller supports, hex keys, and a heavy canvas bag.