Milwaukee M18 FORCE LOGIC 600 MCM Crimper with #8 – 600 MCM Cu Dies (Bare Tool)

Description

Six tons of hydraulic force gives the Milwaukee 600 MCM Crimper Bare Tool the muscle to crush commercial copper terminals. The cordless platform crimps up to 600 MCM copper wire with exact jaw alignment. It uses standard U-dies for versatile panelboard terminations. The bare-tool configuration excludes batteries, requiring existing M18 REDLITHIUM packs for operation.

The frame uses cast aluminum front jaws mounted to glass-filled polycarbonate motor housings. A compact eighteen-volt brushless motor turns a precision hydraulic pump rated for ten thousand PSI bursts. Running current draws fifteen full-load amps under peak compression loads. Tool weight registers at 8.7 lbs without a battery pack, measuring 14.1 inches nose to tail. Its slim profile slips into tight electrical enclosures.

Key Features of Milwaukee 2679-600CU

Contractors buy Milwaukee 2679-600CU packages to handle commercial service drops without dragging heavy hydraulic pump carts. Wholesale pricing on this commercial crimper bare tool lowers capital expense for crews already stocked with batteries.

• C-style open head design allows lateral side entry around continuous commercial feeder conductors.
• Included copper die set fits conductor sizes from number eight AWG through 600 MCM.
• Calibrated hydraulic pressure sensor confirms full tonnage delivery with an unmistakable green signal light.
• Ergonomic center grip balances tool mass to minimize operator shoulder strain during overhead installations.
• Rapid advance piston mechanism shortens cycle duration by closing die gap without delay.
• Rotational 350-degree head spins around tight panel obstacles to access difficult termination lugs.
• Hardened steel die retention detents lock inserts securely during multi-angle conduit pulls.

Hydraulic Tonnage Displacement Bench Evaluation

Laboratory pressure gauges register an exact output of 6.2 tons across 500 MCM copper terminal lugs. The ram reaches maximum travel in 3.4 seconds under full resistance without hydraulic fluid blow-by. Bench tests demonstrate consistent pressure holding within two percent of baseline across fifty continuous terminations. Internal pump casing thermals rise twenty-two degrees Fahrenheit under sustained load cycles. Piston seal friction remains low, ensuring steady stroke velocity until battery voltage drops below fifteen volts.

Field Handling Routine Maintenance Directives

Inline barrel geometry provides clean sight lines to copper lug marks during tight panel installations. Balance sits forward of the wrist, demanding wrist support during continuous bench prefabrication work. Do not use this tool on aluminum utility cable, structural steel punches, or wire rope terminations.

• Wipe die pockets clean with mineral spirits after every ten shifts to clear abrasive copper shavings.
• Inspect jaw alignment pins once a month for lateral wobble, hairline cracks, or structural spread.
• Check battery contacts once a week to clear non-conductive jobsite dust particles and grit.

Warranty Terms Equipment Manifest

Milwaukee backs the bare tool body with a 5-Year warranty covering manufacturing defects and internal hydraulic seals. The package ships with the bare crimper, a fifteen-piece copper crimping die set spanning number eight through 600 MCM, a rugged carrying case, and the factory technical manual.