Greenlee Rebar Die Set with Support System for Strut Cutter

Description

Cut concrete reinforcing bar on the slab without flying abrasive sparks, hot slag, or dulling saw blades. The Greenlee 26RBR-KIT Rebar Die Set fits hydraulic strut cutters to shear rebar stock up to number six size. It speeds up foundation work, though shearing grade sixty rebar demands maximum hydraulic system pressure.

Forged shock-resistant tool steel forms the upper blade and lower receiver die block, vacuum hardened to survive brutal shearing impacts. Operating inside Greenlee hydraulic strut cutters at 10000 PSI, this die set relies on an external hydraulic pump. The complete die and stock support kit weighs 12.5 lbs, with an installed footprint of 7.2 inches long by 5.0 inches wide by 4.2 inches high.

Key Features of Greenlee 26RBR-KIT

Concrete foundation contractors seeking to buy Greenlee 26RBR-KIT systems slice rebar cages without hot work fire permits on commercial jobsites. Industrial cutting accessory pricing reflects the forged tool steel metallurgy and integrated stock support.

• Shears rebar up to number six three-quarter-inch diameter in seconds.
• Forged tool steel blades withstand high shock cycles without edge fractures.
• Integrated material support arm holds heavy rebar level during the shear cut.
• Cold shear process creates zero sparks, open flames, or hot metal slag.
• Produces clean rebar ends that slip into mechanical couplers without grinding.
• Mounts direct into standard Greenlee hydraulic strut cutter stations.
• Reversible cutting edges provide fresh wear surfaces to extend tool life.
• Eliminates abrasive dust and metal grit on active concrete deck forms.

Hydraulic Shear Tonnage Impact Diagnostics

Shearing number six grade sixty rebar draws nine tons of hydraulic ram force. Cycle time completes in 5.6 seconds under 9800 PSI fluid pressure from a commercial electric pump. Blade clearance holds at 0.003 inch throughout the compression stroke, preventing rebar roll or distortion. Hardness testing indicates 59 Rockwell C on cutting edges, resisting deformation from deformed rebar ribs. Cut pieces drop clear through the discharge slot on prefabrication benches without wedging inside the lower die pocket during continuous foundation prefabrication runs.

Rebar Support Ergonomics Negative Filter

Adjusting the outboard rebar support bracket takes seconds, balancing long steel rods to prevent side binding in the die pocket. Foot switch operation leaves worker hands free to position rebar cut marks right under the shear blade. Do not buy this rebar die set for cutting thin sheet metal or hollow structural conduit.

• Wipe rust flakes and mill scale off the die block after each shift.
• Inspect cutting edges for chipping after shearing high-strength rebar bundles.
• Lubricate guide pins and blade contact faces with heavy oil once a week.

Greenlee Rebar Die Warranty Manifest

Greenlee supports this rebar cutting die kit with a 1-Year commercial manufacturer warranty. The factory package contains the 26RBR upper blade, lower receiver die block, material support arm assembly, mounting hardware bolts, and the complete technical setup instruction guide sheet.