Wyco 995 115V 3HP 3 Wire Concrete Vibrator with Quick Disconnect

Description

Shatter air pockets inside thick structural concrete pours with brute electric rotational torque. The Wyco 995 3HP Concrete Vibrator Motor powers heavy flexible shafts and poker heads through stiff low-slump batches. It connects via a fast quick-disconnect coupler. You must run this high-draw motor on dedicated twenty-amp circuits to prevent nuisance jobsite breaker trips.

A cast aluminum housing wrapped in a heavy steel tubular frame shields the internal components from direct drops onto cured slabs. The universal brush motor draws fifteen full-load amps at one hundred fifteen volts single-phase, spinning at fifteen thousand free-load RPM. Total unboxed motor weight sits at sixteen pounds. Dimensions span fourteen inches long by eight inches wide. Internal air baffles route cooling draft away from airborne concrete paste.

Key Features of Wyco W995G1Q

Commercial foundation crews buy Wyco W995G1Q motors to consolidate deep footings without lagging under heavy aggregate loads. Electric concrete vibrator pricing reflects the cast aluminum motor casing built for continuous jobsite abuse.

• Three-horsepower motor maintains high internal head speeds in low-slump concrete mixes.
• Quick-disconnect drive coupling locks flexible drive cores in place without hand tools.
• Three-wire grounded power cord meets jobsite electrical safety codes across commercial builds.
• Tubular steel cage acts as a carry handle and protects switches from impact damage.
• Dual air filtration design prevents fine cement dust from abrading motor copper windings.
• External brush caps allow quick inspection and brush replacement right on the jobsite.
• Double-insulated electrical construction safeguards operators in damp slab prep environments.

Dynamic Torque Bench Test Data

Dynamometer testing shows the motor drops from fifteen thousand free RPM to eleven thousand five hundred loaded RPM in three-inch slump concrete with a two-inch head attached. Amperage draw rises to fourteen-point-two amps under maximum mud immersion, holding stable below breaker trip thresholds. Internal winding temperature peaks at one hundred fifty-five degrees Fahrenheit after fifty minutes of continuous consolidation runs. Armature shaft TIR runout measures under two mils, preventing premature flex core socket wear and vibration transfer into the steel frame.

Jobsite Handling Maintenance Exclusion Realities

The tubular roll cage rests balanced against an operator hip, yet fifteen-amp draw pulls hard on thin extension cords over one hundred feet. The sealed toggle switch flips on with thick rubber mud gloves. Do not buy this three-horsepower motor for light mortar patch jobs or pencil heads under one inch diameter.

• Check carbon brush wear every fifty run hours and replace when worn past half length.
• Blow dry compressed air through motor intake vents at end of shift.
• Wipe drive coupling splines clean before inserting flexible shaft drive pins.

Warranty Terms Factory Package Manifest

Wyco backs this electric concrete vibrator power unit with a 1-Year limited industrial manufacturer warranty. The factory package contains the 115V three-horsepower motor unit, integrated steel roll cage, one spare set of motor carbon brushes, and an operational service manual.