Wacker Neuson IEe58/34/5 Battery-Powered Internal Vibrator for Backpack ACBe (Bare Tool)

Description

Plunge the Wacker Neuson Battery Internal Concrete Vibrator into stiff concrete to achieve rapid consolidation without flexible mechanical cables. Powered by the modular ACBe backpack converter, this 2.3-inch head runs on 34V three-phase high-cycle power. It requires the ACBe backpack unit, preventing standalone wall plug connection or pairing with generic contractor batteries.

Induction-hardened steel forms the 2.28-inch diameter vibrator head casing, precision ground to resist severe aggregate friction in low-slump mix. Head length measures 15.7 inches, coupled to a 16.4-foot heavy-duty rubber protection hose. Bare tool weight registers at 19.8 lbs. The internal high-frequency induction motor turns eccentric weights to 12,000 VPM, drawing current through a sealed quick-disconnect electrical coupling attached to the hose end.

Key Features of Wacker 5100052663

Commercial concrete crews looking to buy Wacker 5100052663 bare tools gain honest commercial battery vibrator pricing while eliminating flex shaft maintenance on deep foundation pours.

• Motor-in-head technology eliminates flexible drive shafts and internal cable core breakage
• Two and one-quarter inch head diameter delivers broad compaction radius across stiff low-slump concrete
• High-frequency 12,000 VPM operation breaks concrete surface tension fast without aggregate segregation
• Induction-hardened steel head casing resists severe abrasive gouging from dense granite aggregate
• Sixteen-foot rubberized operational hose provides ample reach for tall walls and bridge piers
• Direct quick-coupling interface locks onto ACBe backpack converter units in seconds without tools
• Double-sealed bearing design inside the head blocks caustic grout intrusion and retains internal lubricant
• Lightweight twenty-pound bare weight reduces physical fatigue on operators during all-day vertical wall pours

Motor In Head Bench Testing

Bench dynamometer testing under a 34V 200Hz power supply confirms this motor-in-head exciter holds 11,800 VPM under full immersion in 2.5-inch slump concrete, drawing 6.8 continuous amps. Centrifugal compaction force peaks at 980 lbs with radial runout under 0.012 inches along the steel head shell. Stator temperature rise plateaus at 128 degrees Fahrenheit during sustained immersion trials. The internal motor eliminates mechanical shaft twist, maintaining full compaction power whether the hose runs dead straight or bends through dense rebar grids.

Field Usability Realities

Handling this 19.8 lb vibrator head feels balanced, and the absence of rotating drive cables stops hand fatigue from torsional recoil. Hose grip texture stays secure through wet gloves. Do not buy this modular vibrator head for unassisted plug-in use on standard 120V extension cords without the Wacker ACBe battery backpack.

• Rinse wet concrete paste from the steel head and rubber hose with fresh water after each pour
• Inspect the quick-connect electrical coupling pins for dirt or corrosion before snapping together
• Check the steel head casing outer diameter with calipers every three months to monitor shell wear

Wacker Neuson Warranty Manifest

Wacker Neuson backs this internal concrete vibrator head with a 1-Year limited warranty covering defects in materials, motor windings, and craftsmanship. The carton contains the IEe58/34/5 vibrator head, factory-coupled 16.4-foot operating hose, protective connector plug cap, and an illustrated technical instruction manual for immediate field setup.