Wacker Neuson HMS KIT-M2500-SM4S-H35HA Concrete Consolidation Tool

Description

Drive high-frequency vibration deep into slender wall forms without lugging heavy gas consolidation equipment. The Wacker Neuson HMS Modular Vibrator Kit pairs a two-point-five horsepower electric motor with a thirteen-foot shaft to consolidate structural footings. It drives a one-point-four-inch head. The thirteen-foot rubber casing flops when lifted vertically, demanding two workers on staging.

Impact-resistant polymer encases the electric motor housing, protected by a tubular wrap-around steel roll cage. The universal electric motor draws seventeen-point-four amps at one hundred twenty volts single-phase, generating sixteen thousand free-load RPM. Total kit weight sits at thirty-eight pounds. Frame dimensions measure fourteen inches long by eight inches wide. Induction-hardened alloy steel forms the one-point-four-inch diameter high-amplitude vibrating head, linked to a steel-reinforced rubber casing.

Key Features of Wacker Neuson HMS

Commercial foundation crews buy Wacker Neuson HMS kits to consolidate deep stem walls and tight column footings. Modular concrete vibrator pricing reflects the quick-disconnect system that permits rapid changes of shaft lengths and head diameters on active jobsites.

• Two-and-one-half horsepower electric motor maintains high RPM in stiff concrete batches.
• One-point-four-inch high-amplitude steel head consolidates tight spaces between dense rebar grids.
• Thirteen-foot flexible shaft reaches the bottom of tall foundation wall forms.
• Quick-disconnect drive coupling locks shafts onto powerheads without using hand tools.
• Dual air filtration design protects motor copper windings from abrasive cement dust.
• Tubular wrap-around frame acts as a carry handle and protects control switches.
• External brush caps allow fast inspection and brush replacement right on the jobsite.

High Amplitude Head Bench Metrics

Bench dynamometer tests confirm that the head delivers twelve thousand vibrations per minute while submerged in low-slump three-inch concrete mix. Operating current draws sixteen-point-two amperes under maximum mud head resistance, holding constant without rotational drop. Head bearing temperature stabilizes at one hundred forty-four degrees Fahrenheit through sixty minutes of continuous cyclic immersion. Head vibration amplitude reaches sixty-five mils in open air, generating a fourteen-inch effective radius of action in wet structural concrete pours under real shop-floor tests.

Field Handling Usability Negative Limits

At thirty-eight pounds, managing thirteen feet of flexible shaft and the motor demands two workers along narrow wall staging. The heavy toggle switch activates with thick slurry-covered mud gloves. Do not buy this one-point-four-inch head kit for massive open highway paving or deep airport runway slab consolidation requiring three-inch heads.

• Clean and wash the foam motor air filters after every fifty run hours.
• Grease the internal flexible drive core every fifty hours of pour time.
• Inspect quick-disconnect latch pins for concrete grit before locking shafts into place.

Factory Package Manifest Warranty Terms

Wacker Neuson protects this HMS modular vibrator kit with a 1-Year commercial manufacturer warranty. The factory package contains the complete M2500 electric motor, one SM4S thirteen-foot flexible shaft, one H35HA one-point-four-inch vibrator head, a spare air filter set, and official technical service documentation.