Wacker Neuson HMS KIT-M2500-SM3S-H65 Concrete Consolidation Tool

Description

Induction-hardened carbon steel forms a massive two-and-one-half-inch poker head built to withstand continuous abrasion against sharp crushed limestone aggregate. The Wacker Neuson HMS Concrete Consolidation Kit pairs a two-point-five horsepower electric motor with a nine-point-eight-foot shaft for deep commercial pours. It consolidates mass footings. The heavy two-and-one-half-inch head cannot enter narrow wall forms with tight one-inch rebar spacing.

Impact-resistant plastic-coated aluminum housing encloses the electric motor, shielded by a wrap-around tubular steel roll cage. The universal motor draws seventeen-point-four amps at one hundred twenty volts single-phase, driving internal shafts up to sixteen thousand free-load RPM. Total kit weight equals thirty-nine pounds. Frame dimensions span fourteen inches long by eight inches wide. Induction-hardened steel forms the two-and-one-half-inch diameter vibrating head.

Key Features of Wacker Neuson HMS

Heavy civil contractors buy Wacker Neuson HMS kits to consolidate massive bridge abutments and retention wall footings with high-displacement power. Modular vibrator pricing reflects the tool-free quick-disconnect system that permits swapping shaft lengths and head sizes on active jobsites.

• Two-and-one-half horsepower electric motor provides high torque in stiff low-slump concrete.
• Two-and-one-half-inch hardened steel head produces an expansive consolidation radius in mass pours.
• Nine-point-eight foot flexible shaft navigates deep commercial foundation footings.
• Quick-disconnect coupling connects motor to shaft without using wrenches on site.
• Dual air filtration design stops cement dust from fouling internal motor commutators.
• Ergonomic tubular handle frame protects switches from drops and simplifies transport.
• Carbon brushes feature auto-cutoff mechanisms to prevent armature commutator damage.

Mass Pour High Displacement Bench Testing

Bench dynamometer testing confirms that the two-and-one-half-inch head delivers eleven thousand five hundred vibrations per minute under full immersion in stiff two-inch slump concrete. Electrical current draw pulls seventeen amperes under heavy mud drag, maintaining steady motor speed without thermal shutdown. Head vibration amplitude reaches seventy-eight mils in open air, creating an expansive twenty-two-inch effective radius of action inside wet concrete. Shaft coupling runout holds under two mils, preventing premature wear on internal drive core splines during heavy continuous consolidation cycles.

Heavy Handling Maintenance Target Realities

At thirty-nine pounds total weight, lifting this wide head out of wet mud requires strong back leverage from the formwork walkway. The large toggle switch flips on with thick leather work gloves. Do not buy this large two-and-one-half-inch head kit for narrow masonry block cells or thin decorative precast panels.

• Clean and wash the foam motor air filters after every fifty run hours.
• Grease the internal flexible drive core every fifty hours of pour time.
• Inspect quick-disconnect latch pins for concrete grit before locking shafts into place.

Factory Package Manifest Warranty Terms

Wacker Neuson protects this HMS modular vibrator kit with a standard 1-Year commercial manufacturer warranty. The factory package contains the complete M2500 electric motor, one SM3S nine-point-eight-foot flexible shaft, one H65 two-and-one-half-inch vibrator head, a spare air filter set, and complete operating instructions.