ICS 695XL GC Gas Saw Package with 14 In. guidebar and FORCE3 Chain

Description

Feel raw two-stroke muscle plunge fourteen inches deep without overcutting corners using the ICS 695XL GC Concrete Saw Package. This gas-powered diamond chain saw carves square penetrations through reinforced foundation walls. A 6.4 HP engine powers the drive sprocket. You must maintain twenty-PSI minimum water pressure while cutting to flush aggregate grit.

ICS builds the powerhead with an impact-resistant magnesium crankcase mated to an aluminum recoil starter cover. A 6.4 HP 94cc two-stroke single-cylinder gas engine spins the drive sprocket at 11500 RPM, driving Force3 diamond chain at 5600 feet per minute. Machine weight totals 21.4 lbs without bar. Exterior tool measurements span 18 inches long by 12 inches wide by 14 inches high.

Key Features of ICS 695XL

Demolition specialists buy ICS 695XL saw packages to cut clean structural penetrations while checking commercial gas saw pricing. Cutting crews carve square egress window openings, HVAC ducts, and conduit penetrations through fourteen-inch concrete walls without overcutting.

• Force3 diamond chain plunges fourteen inches deep into reinforced concrete, stone, and brick.
• High-displacement 94cc engine delivers 6.4 horsepower to maintain cutting speed in hard aggregate.
• Water delivery system flushes concrete cuttings out of the kerf to keep chain links cool.
• Reversible guide bar extends wear life when cutting abrasive cinder block and cured concrete.
• Decompression valve and digital ignition system guarantee dependable recoil starts in cold weather.
• Wrap-around front handle provides multi-angle leverage when cutting walls, floors, and ceilings.
• Heavy-duty drive sprocket resists aggregate abrasion during continuous deep foundation cuts.

Sprocket Chain Drive Dynamic Tolerances

Bench dynamometer testing confirms stable chain torque under heavy plunge resistance. The 94cc two-stroke engine maintains 9300 RPM under load, driving the Force3 diamond chain through twelve inches of four-thousand-PSI limestone concrete without engine bog. Drive sprocket runout measures under 0.0025 inches TIR on the crankshaft nose. Crankcase temperatures stabilize at 160 degrees Fahrenheit during sustained foundation wall cutting runs. Guide bar water channels maintain twenty-five PSI water flow to cool chain pins and prevent thermal stretch.

Wall Plunge Ergonomics Maintenance Scope

Holding this twenty-one-pound saw against vertical concrete walls demands solid forearm grip and stable scaffold staging on high cuts. The engine decompression button eases recoil pull effort with work gloves. Do not buy this gas chainsaw for dry masonry cutting without water feed, or for continuous highway joint sawing.

• Flush the internal water channels with clean water after finishing concrete cuts.
• Check diamond chain tension and tighten guide bar nuts before each cut.
• Clean the foam carburetor pre-filter sponge every shift to prevent grit ingestion.

Factory Warranty Manifest Packaging Terms

ICS backs the 695XL powerhead with a 1-Year commercial manufacturer warranty against defects. The factory package contains the 695XL powerhead, fourteen-inch guide bar, Force3 diamond chain, rim drive sprocket, scrench tool, two-stroke engine oil bottle, and the printed mechanical equipment operator manual.