ICS 695XL F4 Gas Saw Package with 16 In. guidebar and ProFORCE Chain

Description

Pierce structural foundation walls up to sixteen inches deep without corner overlap or overcutting. The ICS 695XL F4 Gas Saw Package provides deep plunge cutting for HVAC ducts and window egress. A two-stroke gas engine drives diamond chains through reinforced aggregate. Diamond chains demand continuous water pressure over 20 PSI, which stops cutting if water lines falter.

High-strength magnesium alloy forms the crankcase, keeping engine mass manageable while resisting abrasive slurry corrosion. The 94 cc two-stroke gas engine generates 6.4 HP at 9,300 RPM, driving the chain through an internal water-feed drive sprocket. Unboxed powerhead weight sits at 21 lbs, with exterior dimensions of 18.5 by 12.0 by 14.5 inches that stow inside pickup side boxes without guide bar attachment.

Key Features of ICS 695XL F4

Concrete cutting specialists and mechanical contractors run this gas saw for basement egress openings, utility pipe trenches, and structural alterations. Review regional distributor pricing to buy ICS 695XL F4 packages for complex concrete demolition jobs.

• Ninety-four cubic centimeter engine delivers massive torque to drive diamond chain teeth through stone.
• Sixteen-inch guide bar enables deep square cuts without overcutting adjoining wall corners.
• ProFORCE diamond chain segments slice cured concrete, rebar reinforcement, and hard brick.
• Internal water delivery manifold routes pressurized fluid through bar channels straight to chain rivets.
• Rear mud flap shields operator legs from abrasive concrete slurry washback during horizontal cuts.
• Decompression valve vents cylinder pressure to reduce pull cord effort during cold starts.
• Multi-stage foam air filtration system prevents silica dust from entering intake ports.
• Side chain tensioning screw allows rapid tension adjustments using a standard scrench tool.

Drive Sprocket Torque Runout Metrics

Splined drive shaft runout checks out under 0.0012 inches TIR at the clutch interface. The 94 cc engine drops from 9,300 RPM free spin down to 8,150 RPM under full sixteen-inch plunge cuts in hard aggregate concrete. Water delivery pressure holds at 25 PSI, maintaining cylinder head temperatures near 290 degrees Fahrenheit during sustained wall cuts. Chain stretch measures 0.140 inches across the first half hour of operation, requiring take-up adjustment to prevent the drive links from jumping bar rails.

Jobsite Plunge Handling Service Realities

The straight inline chassis design lets operators push straight into vertical walls without motor housing interference. The throttle trigger and master switch respond positive through thick leather work gloves. Do not buy this machine for shallow asphalt expansion joint grooving or light paver installations. Concrete demolition contractors and basement egress teams achieve massive labor savings with this tool.

• Flush guide bar water channels with clean water after finishing each workday.
• Inspect drive sprocket teeth for groove wear when replacing worn diamond chains.
• Wash dry concrete slurry from cylinder cooling fins before sludge turns solid.

Factory Package Standard Warranty Details

ICS backs the 695XL gas powerhead with a 1-Year commercial warranty against manufacturer defects. The factory crate includes the 695XL F4 gas saw, sixteen-inch guide bar, ProFORCE diamond chain, combination scrench tool, and technical operator manual. Water supply tanks, extra diamond chains, and two-stroke oil require separate purchase.