Husqvarna Construction MS 360 HP 2HP 115/230V 60Hz Masonry Saw for Cutting Block Brick or Pavers

Description

Dual-voltage motor wiring gives you the flexibility to switch between residential 115-volt outlets and commercial 230-volt site drops. The Husqvarna MS 360 HP Masonry Saw cuts structural brick, stone pavers, and concrete blocks. A 2 HP motor powers fourteen-inch blades up to five inches deep. Plunging too fast into vitrified stone causes blade bogging, requiring steady hand feed.

Stamped heavy steel builds the chassis tub, with cast aluminum used on the plunge arm to minimize rust from wet cutting slurry. The 2 HP high-torque electric motor runs on 115 or 230 volts at 60 Hz, spinning blades at 3,450 RPM. Bare unboxed tool weight registers 140 lbs, presenting a 44 by 28 by 42 inch working footprint that fits inside service trailers.

Key Features of Husqvarna MS360HP

Masonry crews and hardscape installers deploy this versatile wet saw for decorative patio stone, brick stairs, and block wall veneers. Compare regional equipment pricing to buy Husqvarna MS 360 HP saws for flexible jobsite power compatibility.

• Two horsepower electric motor switches between 115V and 230V power connections with zero complication.
• High-efficiency water containment system channels abrasive slurry back into settling troughs.
• Double-sealed cart rollers travel along rigid rails to produce square mitered stone cuts.
• Mechanical plunge cutting arm enables notch cutouts and deep chop passes in brick.
• Submersible electric water pump floods diamond cutting rims with continuous coolant streams.
• Heavy aluminum protractor guide locks angles for clean forty-five-degree miter cuts.
• Telescoping steel handles pull out to simplify two-man transport into truck beds.
• Stamped steel conveyor cart features a non-slip rubber pad to secure wet stones.

Spindle Runout Dual Voltage Metrics

Arbor spindle runout tests under 0.0007 inches TIR across the blade collar face. Spindle speed drops from 3,450 RPM free spin down to 3,250 RPM when cutting three-inch dense clay pavers on 230-volt power. Motor operating current draws 9.5 amps at 230 volts, staying well below maximum rated thermal capacity. Cart carriage sag measures under 0.003 inches when carrying a sixty-pound stone slab. The industrial belt drive delivers smooth rotational torque without blade shudder during deep plunge cuts.

Site Handling Mason Maintenance Realities

The spring-assisted plunge arm delivers crisp tactile cutting feel, letting operators adjust downfeed rate to match stone density. The sealed toggle switch operates without trouble through gritty mortar gloves. Do not buy this saw for eight-inch structural cinder blocks or outdoor asphalt road joint cutting. Hardscape installers and commercial brick masons will achieve consistent joint quality with this machine.

• Flush settled stone silt out of the water pan at the end of each workday.
• Wipe abrasive slurry particles from the cart guide rails every day.
• Lubricate plunge arm pivot bushings every forty operational hours with grease.

Factory Crate US Warranty Coverage

Husqvarna protects this masonry saw with a 1-Year limited commercial warranty covering the electric motor, pump, and mechanical frame. The shipping package contains the MS 360 HP saw unit, submersible water pump, protractor angle guide, arbor wrench, and operator manual. Fourteen-inch diamond blades and wheel stand kits ship separately.