Edco DS-18 5 HP 230V 18in Walk-Behind Saw

Description

Feel the solid mechanical tracking stability as you feed eighteen-inch diamond blades through warehouse concrete floors. The Edco DS-18 Walk-Behind Saw delivers fume-free slab jointing for indoor commercial renovations. A 5 HP electric motor drives blades down to six-and-three-quarter inches. The heavy electric frame requires dedicated 230-volt single-phase power, tethering operations to heavy power drop cords.

Heavy seven-gauge welded steel plate structures the chassis frame, damping vibration to prevent joint edge spalling. The 5 HP continuous-duty electric motor operates on 230-volt single-phase power, drawing 23.5 FLA at 3,450 RPM. This industrial walk-behind saw weighs 265 lbs unboxed, operating within a 44 by 24 by 39 inch footprint that maneuvers inside commercial doorways and service elevators.

Key Features of Edco DS-18

Concrete cutting contractors and industrial flooring crews run this electric saw for expansion control joints, electrical conduit chases, and interior slab demolition. Request commercial quotes to buy Edco DS-18 floor saws for clean indoor concrete cutting operations.

• Five horsepower electric motor supplies clean indoor cutting power without exhaust fumes.
• Seven-gauge welded steel chassis prevents frame deflection to keep cuts plumb and straight.
• Precision screw-feed crank raises and lowers the cutting arbor with mechanical accuracy.
• Heavy-duty dual arbor belts deliver full motor torque straight to the diamond blade.
• Blade shaft rotates on greaseable pillow block bearings designed for wet slurry exposure.
• Integrated water distribution manifold directs cooling streams onto both blade faces.
• Front pointer guide wheel tracks chalk lines across large open warehouse slabs.
• Wide rear transport wheels roll across cracked concrete without dropping into joint gaps.

Electric Motor Load Depth Metrics

Arbor runout checks out at 0.0009 inches TIR across the 1-inch blade collar. Under full six-inch plunge passes in 4,500 PSI cured concrete, motor speed drops from 3,450 RPM free rotation to 3,290 RPM under full load. The motor draws 22.8 running amps, remaining below thermal overload thresholds during continuous cutting passes. Frame deflection holds under 0.004 inches under downward screw feed pressure. Drive belts transfer torque with less than two percent slip when tensioned to factory specifications.

Jobsite Usability Operator Service Realities

The balanced 265-pound frame tracks straight with gentle operator push force, keeping fatigue low over thousands of linear feet. The magnetic emergency shut-off switch mounts within instant hand reach on the upper console. Do not buy this machine for off-grid outdoor road cuts lacking high-amp electric generators. Commercial electrical contractors and indoor renovation crews gain immense production efficiency from this setup.

• Lubricate blade shaft pillow block bearings with lithium grease every twenty hours.
• Inspect dual drive belt tension and check belt alignment after initial ten hours.
• Flush slurry sediment out of the water delivery tubes after every workday.

Factory Crate US Warranty Terms

Edco protects this walk-behind saw with a 1-Year commercial warranty covering the electric motor, chassis, and arbor assembly. The wooden shipping pallet contains the DS-18 saw unit, arbor wrench set, pointer bar, and technical service manual. Eighteen-inch diamond blades and 230-volt power drop cords require separate purchase.