Makita 80V max (40V max X2) XGT Brushless 70 lb. 1-1/8 Inch Hex AVT Breaker Hammer 8 Ah Kit, AWS Capable

Description

Trailing generator cables across busy highways present severe trip hazards during urgent utility line repairs. The Makita 80V max (40V max X2) XGT Brushless 70 lb. 1-1/8 Inch Hex AVT Breaker Hammer 8 Ah Kit, AWS Capable smashes reinforced foundation footings without generator cords. Operating on two 40V batteries in series, this 70-pound cordless breaker yields 53 ft-lbs of impact energy. Pushing down off-axis on the chisel jams the internal striker stops, draining battery cells without fracturing rock.

A dual-battery brushless motor turns a precision-cut steel crankshaft to drive an air-cushioned striker piston. The 1-1/8-inch hex tool chuck features hardened alloy steel locking pawls ground to resist severe axial hammering wear. Anti-Vibration Technology incorporates an active internal counterbalance weight to neutralize heavy impact recoil forces. Dual sealed armature bearings keep conductive silica dust out of internal motor windings. Fine concrete dust entering battery terminal bays causes poor terminal contact and intermittent electrical shut-downs under heavy vibration.

Cordless Road Breaker Hardware Specifications

Utility contractors require heavy roadway demolition power without the toxic fumes and trip hazards of engine-driven breakers. The cordless architecture pairs a high-output brushless motor with an internal mechanical recoil dampener.

• Brushless motor converts 80-volt dual battery power into 53 ft-lbs of destructive kinetic impact energy
• 1-1/8-inch hex tool chuck retains heavy pavement breaker steels, asphalt cutters, and tamping pads firmly
• Internal counterweight mechanism cuts handle vibration acceleration to minimize operator joint fatigue
• Auto-Start Wireless System pairs via Bluetooth to activate paired jobsite dust extractors automatically
• Two 8.0Ah XGT lithium-ion batteries deliver sustained high-output power for heavy slab breaking passes
• Rubberized suspension handles isolate the operator from destructive linear pavement rebound forces
• Integrated battery cage protects lithium cells from heavy impact shocks and falling slab debris

Battery Driven Kinetic Telemetry Analysis

Current draw pulls up to 60 amps across the 80V battery circuit during continuous breaking in highway concrete. The mechanical piston cycles at 870 blows per minute. Kinetic strike energy outputs 53 ft-lbs per stroke into cured foundation slabs. Internal compressive air friction elevates the cast aluminum barrel to 142°F during continuous work passes. The 1-1/8-inch hex chuck absorbs up to 210 ft-lbs of off-axis chisel pry force. Sound pressure registers 98 dBA.

Heavy Slab Demolition Care Boundaries

High-voltage battery breakers demand strict battery cooling cycles to avoid thermal shut-down. Residential trim carpenters should not purchase this 70-lb breaker because its massive impact fractures surrounding timber frames. Forcing the chisel into concrete beyond its collar depth risks jamming the tool steel permanently in the slab.

• Grease the 1-1/8-inch hex shank of every breaker steel before inserting it into the tool chuck collar
• Clean road dust and asphalt tar from the chuck locking mechanism using a solvent brush daily
• Wipe fine masonry powder from the battery terminal contacts before locking battery packs into the tool

Commercial Warranty Terms Pack Roster

Makita supports this 80V XGT breaker kit with a 3-Year limited warranty covering the brushless motor, electronics, and mechanical drive. The kit contains the GMH04 breaker, two 40V max 8.0Ah batteries, a dual-port rapid charger, two 1-1/8-inch hex chisels, and the operating manual.