mec 20 Ft. Electric Vertical Mast Lift

Description

Low-level commercial maintenance requires compact vertical access that navigates crowded mechanical rooms. The mec 20 Ft. Electric Vertical mast lift provides 19-foot 8-inch platform elevation through standard interior single doorways. Operating hydraulic pressure limits at 2000 PSI. Ground clearance sits at 2.5 inches, causing frame bottom-out risks when crossing steep threshold transitions or equipment ramps.

Extruded aircraft-grade aluminum mast sections interlock with low-friction polymer guide wear pads, preventing metal-to-metal contact during extension. The chassis features welded structural plate steel that places machine ballast low between the non-marking wheels. Dual front-wheel direct electric drive motors provide efficient propulsion without hydraulic drive lines. The single hydraulic lift cylinder features a micro-honed steel barrel and chrome-plated piston rod driven by a compact 24-volt electric pump.

Vertical Mast Drive Hardware Architecture

Electric drive motors deliver zero inside turning radius for nimble maneuvering in tight storage rooms. Direct electric drive delivers long battery run cycles on flat indoor concrete.

• 19-foot 8-inch platform height reaches 26-foot working heights on commercial ceilings.
• 350 lb platform load rating supports one technician plus heavy pipe fittings.
• 32-inch chassis width passes through standard interior doors without jamb contact.
• Zero inside turning radius enables full 360-degree rotation in narrow corridors.
• Direct electric drive motors eliminate hydraulic drive hoses and floor stain hazards.
• 20-inch roll-out extension deck provides extra reach over stationary ground obstacles.
• Non-marking solid rubber tires safeguard polished terrazzo and epoxy floor surfaces.

Electric Power Telemetry Thermal Data

Digital ammeter testing shows the electric drive motors consume 14 Amps at 2.5 MPH travel speed across flat slab concrete. Platform elevation draws 72 Amps at 24 Volts under full 350 lb payload capacity. Electric motor controller temperature measures 116°F after five consecutive elevation cycles. Hydraulic oil in the 1.5-gallon reservoir warms to 112°F during repetitive cycle testing. System relief valve limits pressure to 2000 PSI. Acoustic sound meters record 58 dBA at 7 meters.

Floor Boundaries Scheduled Fleet Directives

Never run this vertical mast lift on exterior earth, gravel paths, or ramp slopes exceeding 25 percent. The small drive wheels will spin out and ground the low chassis plate.

• Check battery water levels and clean post connections every 30 operating hours.
• Inspect mast guide wear pads and check sequencing cable tension every 100 hours.
• Drain hydraulic tank and replace the suction screen filter every 1000 operational hours.

Commercial Warranty Standard Shipment Package

MEC backs this machine with a 2-Year commercial warranty combined with 5-Year structural mast protection. Shipment package includes the assembled electric mast lift, 24-volt deep-cycle battery bank, onboard smart charger, proportional platform control box, descent alarm, and complete technical user manual.