JLG 26.2′ Rough Terrain Scissor Lift 4.5kW Electric Power 2WD

Description

Uneven construction terrain demands high platform loads without combustible engine emissions. The JLG 26.2′ Rough Terrain Scissor lift delivers clean electric operation with a massive 1500 lb platform capacity. Hydraulic system pressure peaks at 3000 PSI. The two-wheel drive propulsion system will slip on wet clay grades without solid ground pack underneath the drive tires.

Heavy-duty structural steel box sections form the multi-tier scissor linkage, supported by induction-hardened cross pins and low-friction composite bushings. Power comes from a 48-volt battery pack driving a 4.5kW electric motor coupled to a heavy-duty hydraulic pump. Rear-wheel drive hydraulic motors route torque through cast iron planetary reduction hubs. A front oscillating axle articulates four inches, holding ground contact across ditches without chassis twisting.

Electric Rough Terrain Powertrain Hardware

Heavy steel deck platforms stage extensive cladding and mechanical supplies without intermediate ground trips. Electric power delivers silent operation inside partially enclosed commercial structures.

• 26-foot 2-inch platform elevation reaches a 32-foot working height on structural walls.
• 1500 lb platform capacity supports four tradesmen plus installation inventory.
• 5-foot slide-out deck extension provides broad horizontal workspace over jobsite obstacles.
• 4.5kW electric power plant delivers sustained hydraulic pressure without exhaust fumes.
• Oscillating front axle maintains wheel ground contact across rutted building sites.
• Foam-filled rough terrain tires resist puncture failures on demolition concrete.
• 35 percent gradeability rating climbs standard equipment trailers and access ramps.

Electrical Load Heat Bench Telemetry

Ammeter readings confirm the 48-volt system draws 160 Amps during simultaneous platform elevation with full 1500 lb ballast. The 4.5kW motor casing temperature reaches 138°F after thirty minutes of continuous lift duty. Hydraulic fluid within the 16-gallon reservoir warms to 134°F during repetitive cycle testing. System hydraulic pressure holds at 3000 PSI at cylinder stroke ends. Sound pressure meters record 64 dBA at 7 meters during maximum speed transit.

Jobsite Constraints Maintenance Directives

Do not run this unit through deep mud bogs or standing water pools above the lower wheel rims. Water ingress will damage the electronic wheel motor sensors and planetary seals.

• Grease all eighteen scissor linkage pivot zerks every 50 operational hours.
• Check specific gravity across all 48-volt battery cells every 30 operating hours.
• Sample hydraulic fluid and replace pressure line filter cartridges every 1000 run hours.

Commercial Warranty Crate Manifest Items

JLG backs this equipment with a 1-Year comprehensive commercial warranty paired with 5-Year structural frame and scissor arm protection. Unboxing package contains the rough terrain scissor lift, 48-volt battery pack, high-output industrial charger, platform control console, deck extension module, and factory maintenance documentation.